Cant identify resistor color code

Without a circuit diagram or another actual unit to look at it is very difficult to identify burnt out resistors. Even harder is finding out why it burnt out because most of the time a resistor only burns out if overloaded due to other circuit component faults.

I have a Pioneer PDP-503CMX with a blown resistor that is labeled R133 too. Here's a pic. Based on the color coding, I think it's a 0.1 ohm resistor.

HI.We cannot really but identify the correct resistor value unless we can identify or determine the color coding on the resistor.Each color has a corresponding value and tolerance as well.If you can't indentify the color coding then you can refer to its diagram usually printed out on the side of the control board or near thecontrol board.We cannot but cannot give a guess value unless color coding is given.Thank you for choosing FIXYA.

If colors are available, get a color chart for resistors and you will ascertain the value for replacement.

According to you your machine's resistor burnt out. This resistor is located above the 240 volt capacitor which white base. change the resistor soon. For color code of the resistor you can follow the manual. You can visit also the product website for tech assistance.

The color stripes on the resistor should tell you.
If it does not have colored stripes, it is a diode or something, and not a resistor. Find another the same color, and measure it with an ohmmeter. Trial and error works if you start with one having greater resistance.

Hello,
You can determine the resistors value by reading the color code bands that are marked on it. The following picture is an example of the color codes and there values.



To show you how to read the color codes on a resistor, I am including a link to a video that will explain how to do this easier than I could probably explain it.

I hope this helps you in solving the problem. If you need further assistance please feel free to ask.

If you would not mind, please rate my help. I would greatly appreciate it. Thank You

hi,
I had the same problem before. I open my set to find out the faulty component are at power supply main board.
I change the electrlytic capacitor 680microfarad and a resistor burnt near the FET.
You can visual check first.Color changes and bulky form on cap and burnt resistor easily.
Have a try.

Is this a Hitachi set? If so then check the model number and be sure it's right.

Researching resistors---

What caused the resistors to burn?? Have you already fixed

that? If so, what exactly was it ???   let me know...T.