Question about Hayward 2HP Pool Pump Motor A O Smith Electric Pool Motor for 56J Frame

Open Question

I got a bft gate motor ; when i push the remote the gate motor wants to start but it turn a litte then stop i have change thecapacitor but still the same

Posted by Anonymous on


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have an ET 500 gate motor. My neighbour's remote opens my gate as well when she opens her garage door. How can I change my ET receiver to prevent the neighbour opening my ET gate motor?

Most garage door openers and I assume gate actuators have jumpers or settings if computerized to change frequencies.
Both the remote and unit will have to be changed.

Aug 05, 2016 | Building Materials

1 Answer

Why is my circuit board showing KO when trying to add new remotes

It means that it has not programmed your new remote ie not compatable with your system or damaged hope this helps

Mar 03, 2016 | BFT R93524500001 - Swing Gate Kit, Single,...

1 Answer

Circuit board showing KO when trying to add new remotes

It means that it has not accepted it ie not compatable or damaged taken too long to do the prcedure or wrong procedure hope this helps

Mar 03, 2016 | BFT R93524500001 - Swing Gate Kit, Single,...

2 Answers

Have a BFT Phobos BT gate opener. The problem I am having is my gate won't close all the way. There is a small gap. I tried to set the limit switch by removing the screw but it isn't...

The opener may have been mounted improperly or may have slipped from it's original mounting location. You may not be able to make an adjustment because the arm is already fully extended.
You may have to re-position the gate opener.
Fixya doesn't do repairs. Posting a question here is like calling the public library for an answer that they can look up.

Feb 02, 2015 | BFT R93524500001 - Swing Gate Kit, Single,...

3 Answers

Hi,, i have a SL3000UL slide gate opener that stops half way.

well it seems like you have checcked almost everything. there are two things that come to mind that might be your problem, check the backup battery, messure it while on charge with a multi meter, the reading should be between 13.4v and 14.0v. if this is fine then if you have beams or loops installed try replacing them as they might be faulty.

Dec 04, 2013 | Elite Sl 3000 Ul Sliding Gate Operator

1 Answer

Bft gate stays open

your problem could be either photocells faulty or end of run connections miniatur reed switch or roker type next to the motor. i trust the motor is working? you can try to bridge the photocells connectors and also bridge the end of run connectors try one at the time and see how you get on ok?

Apr 01, 2013 | Array BFT IGEA BT Kit Single Operator 24V...

1 Answer

How to program bft ares 1000 remote

The BFT site has an installation/programming manual for download.

It has charts of the codes and programming instructions.

Oct 24, 2012 | Televison & Video

1 Answer

My gate starts to open but then stops

Need more information.
Firstly, engage the manual release inside your motor and then operate gate by hand. Pay attention to any spots that are hard to push, this would indicate some sort of mechanical obstruction causing the motor to stop. Try remove obstruction.
Secondly, measure the voltage on your battery while trying to operate the gate. If your battery drops below 11.5V the control board will shut down. If so, replace battery.

Feb 04, 2012 | Apollo 7000etl Slide Gate Opener Plus 2...

1 Answer

My gate is equipped with a D3 Centurion gate motor. When I push the button to open the gate, the motor turns in the opposite direction (close) and tends to close further. Then if I deactivate the gear box...

if you push the open button and it closes indicates that you have the wrong polarity connected to the motor
gate motors are DC so where the positive and negative wires are connected are critical for rotation direction of the motor

Jul 29, 2017 | Garden

Not finding what you are looking for?
Hayward 2HP Pool Pump Motor A O Smith Electric Pool Motor  for 56J Frame Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hayward Pool & Spa Experts

john h

Level 3 Expert

23515 Answers


Level 3 Expert

85239 Answers

Paul Carew

Level 3 Expert

3527 Answers

Are you a Hayward Pool and Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides