Question about Mitsubishi WD-52525 52" Rear Projection HDTV
Error code 32 no picture flashing red lamp light
The lamp cover is not installed properly or the lamp door switch isnt working thats what causes the 32 error.
Posted on Apr 08, 2013
There are two 1000uf 16V capacitors on the PWB that cause that problem code 34 lamp abnormality. If you need more info let me know.
Posted on May 04, 2008
The hardest part is getting the chassis block out. But if youre mechanically inclined and follow the illustrations and label all the wires you unplug, its not that difficult a job. The soldering isnt very difficult as theyre just capacitors. The chassis is contained inside a metal container and has to be removed as a unit then opened up to get to the PWB PC board.
Posted on Jul 06, 2008
SOURCE: WD-52525 Red lamp Indicator
usually with that model when you get a 34 eror code for lamp abnormality, its directly related to the capacitors on the Power Pwb. You can get the V26 Power PWB repair kit at the following link which repairs that issue. It contains the replacement High temp capacitors with the board location numbers and PWB identification as well as the service manual on CD. Heres the link its under their repair kit ctegory.
Posted on Sep 04, 2008
You have to take the TV apart. Pull the electrical chassis out and look for bad electrolytic caps on the boards. The red LED probably means the 2 - 3300UF caps on the power supply board are bad. You can tell if they are bad by the fact that their tops are puffed up and they may or may not be leaking brown fluid. Compare them against the other caps on the boards and you will see how they have flat tops.
BUT before you take the TV apart you can check the error codes by pushing "menu" and "Device" at the same time and holding for about 10 seconds. The status light will blink two numbers. ex. one flash pause two flashes is 12 Error Code Probable Cause
12 No error detected
22 Recovery from momentary Reset
32 Lamp Cover open
33 Air Filter Cover open
34 Lamp abnormality
35 Chassis Fan failure
36 Exhaust (Back Cover) or Lamp Ballast Fan failure
37 Engine (DMD or Lamp) Fan failure
38 Excess Lamp Temperature
39 Excess DMD Temperature
41 Short Detected
44 DVI Cable (between Chassis and Engine) disconnected
or use this table -
You can buy replacement caps from Mouser electronics online. There are plenty of solutions detailing how to do this already posted.
Posted on Jan 11, 2009
Tips for a great answer:
Sep 11, 2010 | Mitsubishi WD-52525 52" Rear Projection...
Sep 02, 2009 | Mitsubishi WD-52525 52" Rear Projection...
Jan 09, 2009 | Mitsubishi WD-52525 52" Rear Projection...
Sep 04, 2008 | Mitsubishi WD-52525 52" Rear Projection...
Jun 17, 2008 | Mitsubishi WD-52525 52" Rear Projection...
May 06, 2008 | Mitsubishi WD-52525 52" Rear Projection...
May 04, 2008 | Mitsubishi WD-52525 52" Rear Projection...
Feb 17, 2008 | Mitsubishi WD-52525 52" Rear Projection...
Jan 29, 2008 | Mitsubishi WD-52525 52" Rear Projection...
Jan 18, 2008 | Mitsubishi WD-52525 52" Rear Projection...
132 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: