Jvm3660 dead no display or power, just seems dead

Blown fuse inside of unit. Must find out why fuse blew, something shorted or bad connections.

Click below for the manual: (see page 29)

Manual

Hope this helps

Zeppelinx12

The circuit board must be replaced.

You can remvoe the bottom of the microwave without taking it off the wall. This page talks about this problem. http://www.appliance-repair-it.com/microwave-turntable.html

Hello :

F-3 error is an error code for a bad keypad . If you couldn't find the spare parts , then it will be cheaper to replace the microwave.

good luck .

please rate !

Go to any hard ware store for fuse or Home depot. If still dead it could be a bad magnetron, power supply or logic board. Home Improvement Made Easy with New Lower Prices Improve Repair

i had same problen, i changed the fuse inside the microwave, works good now

Does the display light up?
Are you sure it is getting power?
Check that and get back to us cause the next step is going inside

So it's dead, but sometimes the inside lights come on? Does the display come and go, too? If so, and power is getting to the board, this is a problem with the control panel assembly, which we repair nationwide for $39.95. Full information on our service is available at our site, which is linked at our listing here on FixYa: http://tinyurl.com/yzjozk

This is a problem with the control panel assembly, which we repair nationwide for $39.95. This is most often caused by the filaments shorting when the bulb blows, or by not disconnecting the microwave from the power line when removing or installing a bulb. Full information on our service is available at our site, which is linked at our listing here on FixYa: http://tinyurl.com/yzjozk