I put a cd radio in my lesabor and it was working till i put it in the dash then it stoped working ????? no clue what happened.

cant fix till it happens agin as problem has gone prob loose conection

could be a fuel filter

you will need to find the security code for radio and put put that in for radio to start working again

if it is factory radio most car makers put a sticker in glove box that only has some numbers on it and no other info - that is usually the radio unlock code

if it is aftermarket radio it might be stuck into the owners manual - which will also tell you procedure for putting that code into radio

only other thing i could think of is that a fuse for radio has blown

good luck

check back of radio make sure your speakers attached or plugged in

my timex t436b's radio stoped working on f.m. but a.m., audo in works the sounds work so if you have any clue how to fix it please tell me

Durabrand products are prone to alot of problems!!! In other mords they really ****!!!

My same model did this too. The wiring harness may have gone bad. Try direct wiring the stereo or replacing the wiring harness if you can get one. This fixed the problem for me.

Lighting of the lcd ? Could be an internal radio component. Check the web - seems to be fairly common with the radio ( made by Panasonic) where there is a small resistor that gets fried and results in the loss of the lighting . The CD changer also has problems.. I should know.. It happened to my 03 Accord also.. You can get a remanufactured unit on ebay for < $100 . Also, there are online tutorials on how to remove the radio. Good luck

hi there
open up your dash get 1 short RCA cable (red and white) male ends on them
now place the red and white RCA into the back of DVD in-dash player next step the aftermarket CD player should have 2 rca plugs that say aux put the other end red and white RCA cable that you just put into DVD unit into the aux inputs on back of CD player when this is done reinstall both units back into the dash now on your CD player press the source button till aux appears once this is done you will hear the DVD player sound...........now if you press the source button and no aux appears......hold down the source button till the CD player powers off...........once CD player is off hold down the F (function) button till beep or unit turns on a display use the skip buttons or F (function) button to go threw features once you get to aux turn aux to on now hold the source button down again till unit powers on normally once this is done press source button again till you find aux........if you get sound and the TV doesn't work let me know and ill guide you to get that running too (if there are no aux RCA plugs on the back of CD player) let me know (sometimes there is a headphone looking plug on back of CD units) if what i told you doesn't work let me know the brand of CD player you have so i can give you correct setups I'm only going by your in-dash DVD player right now
hope i was able to help get you sound

slide them down the two enads of radio you will have to pop off the narrow trim bezel around radio to do this