- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The top to bottom alignment is done by moving the hinges up/down. On many models there may also be plastic spacers on the hinge pins you can use to adjust the height.The closing of the door so it shuts properly and is flush on all 4 sides is done by adjusting the screws that hold the door gasket in place. If you've never done it before it can be a real pain to get it right. Make small adjustments to the screws and if need be grab the door at the center top and center bottom and give it a small tug in opposite directions to get it straight, if you have to. To test if its closing properly, look at the edge of the gasket all around it should be the same distance from the body of the fridge, use a mirror to see the bottom. To test if its sealing properly use a dollar bill. Close the bill in between the gasket and the door in areas all around the door, When you pull on the bill you should feel resistance, if the bill is not held in or pulls out easily the gasket is not sealing properly at that location, you need to adjust the screws to get it aligned better.
The problem can be temperature not set
properly or any of fridge or freezer door not closed properly and cool air is
getting leaked out. These are basic possibilities which first need to be checked.
But if these possibilities are checked ok and still the problem is same, then
its weak compressor issue. Click the link below for more details:---http://technoanswers.blogspot.com/2011/06/both-refrigerator-and-freezer-not.html
This may help ... it is not your exact model but it is a Kenmore side by side.
How to .Remove the Control Panel Bezel on Kenmore Coldspot Model 59282990...
It appears there are two clip slots on the bottom of the trim plate that need to be carefully pried to release the 2 pressure clips ... then swing the trim out a bit and lift up.
Hopefully your model is just like this one .. or close anyway!
Good luck on your troubleshooting!
these have to be in correctly to lock back in and allow the unit to function. Try removing the bin again and be sure there isn't any small pieces of ice trapped anywhere. Also make sure there aren't any broken pieces from the bin. Hope this helps. Good luck.