Replacement scooter kets from uk suppliers

I would suggest that if you borrowed this, the person you borrowed it from needs to tell you where it should be taken for further troubleshooting. It is beyond what I can help with!

hi ,this will help

http://www.invacare.com/doc_files/1143205.pdf

if you need more info , contact me ,,,I'm here to help...

Regards
Rob

www.gewizrepairs.co.uk

You mean you're not getting Keys to your Scooter......Contact Authorized Dealer and you'll get New Keys after providing them with Satisfactory Documentation (Your Scooter's Chassis & Engine Number, Date of Purchase, Registration Details etc.).

hi, please can you tell the number of flashes before a pause then it starts flashing again ?

Regards
Rob

www.gewizrepairs.co.uk

your parking brake is on. its in the book

Your scooter has an auto lockout timer. After it sets with the key on, for a determined amount of time, ( all scooters times are different) it will lock out and you have to turn the key to the off position for 9 seconds and then turn it back on. A good idea is to turn the key off when not moving.
When you turn the scooter on just wait 9 secnd before pushing the throttle.

Good Luck
Tim

Soutside how secure does the scooter have to be? Is it parked inside at night and does your partner leave it unattended for long? The reason I'm asking is because you can replace the keyed switch with a plain old on/off toggle switch for about 5 bucks. Just remoce the console unscrew the old keyed switch unplug the old switch from the wire harness and using the original connector splice the toggle swith to the connector tape with electrical tape and install in console. Check correct operation of the switch before you put it in the console. If it works ok install it and put the console back together and there you go a fix plus cheap too You can always call Invacare @ 1-800-333-6900 and order a new switch Hope this helps.

Hi. Sounds like the switch in the lock assembly is faulty. If you join together the two wires from the scooter to the lock assembly, this will be the same as turning on the key.This will let youknowif the lock was faulty or if there is another fault. If there is a connector on the wires then make up another connector that fits the one on the scooter, with a loop of wire to complete the circuit.You might be better off to buy a whole new lock assembly with the lead and connector already attached. If you are not confident working with electricity, then ask a local service technician to do it for you.Good luck. Neil.

Hi , I cannot locate the lynx 4 manual however I have located a lynx 3 manual with I been told is similar.

http://www.rentascooter.com/downloads/_manuals/invacare/Invacare%20Zoom-3%20Lynx%20and%20Panther%20Series%20Owner's%20Manual.pdf

Regards
GeWiz.

most keys for that type of scooter are the same, (not like a house or car key) call Pride 1-800-800-8586 for replacement or any Pride dealer can help you. Also, a paper clip can jump the ignition by placing it in their to get you around temp.