Question about Konica Minolta Di1610 Copier

3 Answers

IError Code C13FO on konica minolta Di1610

I didnt find Error Code C13FO i need assistance thanx

Posted by Anonymous on

Ad

3 Answers

Konica Minolta Error Codes and Solutions

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 210 Answers

C13F0 - Laser error
The laser output exceeds the upper limit value.
The laser output remains lower than the lower limit value.

Posted on Aug 23, 2009

Ad

Adorjani Laszlo

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Konica Minolta Master
  • 1,316 Answers

HSYNC detect abnormal.

Posted on Aug 05, 2009

Ad

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Error code for Develop Ineo 160

Posted on Sep 29, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

How to get the radio code


I need a radio code for my 2003 Acura TL . I retrieved the radio serial # by holding down the 1 and 6 buttons on my radio before turning it on. The radio's serial # is U3000L0219. Can you please assist me with this problem? Thanx

on Sep 15, 2010 | 2000 Acura TL

1 Answer

Fisher & Paykel WL26CW1 - Error Code 49! can i swap the hot and cold valves to make it work and disconect the hot valve?? and love this site very informative, Thanx Guys..


The most common problem with AquaSmart is the pump
not the water valves
The pump has gone bad and blown some parts in the motor controller board and the fuse to the water valves.
Some AquaSmart machines display the wrong Error code (49)
witch is not the correct code for this problem.
Pump and motor controller board need replacing.
Maybe cheaper to buy a good secondhand machine.

Mar 19, 2014 | Fisher and Paykel WL26CW1 Top Load Washer

1 Answer

I NEED THE CODE


Hi,

You can download the manual from below website.In that manual you have the codes

http://www.rockabilly.net/manuals/manual.shtml?URC-3021

As you didnt mention the type and make of your device i couldnt give you the correct codes.If possible please give me the type and make of the device to assist you better

thanx

Aug 06, 2010 | One For All URC-3021 Remote Control

1 Answer

I get a code ( C13FO)


This error usualy relate to internal software, and internal hardware communications.
Check cabling and connectors to the PH (PrintHead) unit and the printed circuit board (PWB-A).
If they are OK, the change the PH (PrintHead) unit or the PWB-A

Most likely a PH unit (laser scanner) failure...

This will need a service technician to repair, as after replacing the PH unit, there are several adjustments that are required to be done,

Dec 20, 2009 | Konica Minolta DiALTA Di200 Copier

2 Answers

Helloo about toshiba e studio45 i have error code CB1 , this machine is a secound hand and when it desplay the service error it shows the contact number for the maintenance i need to remove it too but i...


this is a finisher error code.
turn off power then grasp the lower tray of finisher on both sides and shift up as far as it will go. turn power back on and see if that works. worse case disconnect the finisher from top rear of machine-at least the copier should still work and copies will go into middle.

Oct 04, 2009 | Office Equipment & Supplies

1 Answer

I need code for radio on a 1995 volvo 850 glt


The dearlers are the only ones to deactivate a stereo code, I tried on my car and found no other sources but the dealer. All they did was run my VIN and found a solution and reactivated my stereo. this was on my 02 gm pickup. Please rate thanx... Charles

Aug 21, 2009 | 1995 Volvo 850

1 Answer

Error codes E020/04E0 and E061/0040


Clean the thermistors and the thermofuses the first copier,to second copier vacuum cleaning the suction fan ventilator and ozone filters.

Jul 22, 2009 | Canon CLC 1180 Copier

1 Answer

Officejet power reset error code


I have a error code that is 0xd05d010d I have tried reinstallin g drivers and software didnt work. tried unpluging power cable and holding ok and cancle buttons and plugging back in didnt work. now Im not sure what to do can you help please.

Jul 08, 2008 | HP Officejet 5610 All-In-One InkJet...

Not finding what you are looking for?
Konica Minolta Di1610 Copier Logo

Related Topics:

1,142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Konica Minolta Office Equipment & Supplies Experts

Norman  J Weimar Jr
Norman J Weimar Jr

Level 3 Expert

6960 Answers

carpediemweb

Level 1 Expert

54 Answers

George Mclaughlin

Level 2 Expert

369 Answers

Are you a Konica Minolta Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...