After resting problem getting screen back - Mag Innovision Computers & Internet

• Remove the battery cover from the back side of the cell phone. Remove the battery from its compartment and set it aside.
• Use the screwdriver to remove the Phillips-head screws from the back panel of the cell phone. You may also need to remove the antenna from its retaining slot and remove it from the cell phone if you can
  
• Separate the back panel of the cell phone from the rest of the cell phone's body. Place the cell phone face up and then remove the cell phone's faceplate from the rest of the cell phone. This should leave the LCD screen, keypad and circuit board completely exposed.
  
• Tilt the LCD screen downward and then disconnect the LCD screen's ribbon cable from the LCD screen and set the screen aside.
  
• Repeat this procedure in reverse to replace the LCD screen and reassemble the cell phone.
  

check the power setting in your system on the right side task bar. where u ll find it. change the setting of that power consumption thn chk it out.!!!

screen driver has gone on the back of the screen you are getting split screen effect.some times it may just be a bad conection on the screen drive to the screen cables at the top.

what you can do is to remove the back cover to access the inverter board. probably the cause of the smell is burned inverter board for the screen back light ( ccfl ) at the upper portion of the display.you can find the inverter board near the power supply board. usually you will replaced the inverter board since most of the part get fried as will as the pcb pattern circuit board get burnt.hope this can help good luck.

The error code means there is some thing wrong the fixing unit. I believe it for to many paper jams in the fixing unit. Remove all of the paper jams and to rest it > Turn the Main power Off and when turning the copier back ON, press and hold the utillity button till the screen changes and the Trouble rest show on the display screen. Press the "OK" and let it do it's thing & then turn it off and back ON. Good Luck

there will be an options in your bios on start up you will get a screen with your manufacturers logo and usually at the bottom of this screen it will tell you what key to press to get into your bios or you can remove the left hand side of your case and then remove the battery for a minute on your motherboard then put it back in and your motherboard will be reset to its original settings

It seems from your discription like your lcd back light my be failing, i suggest taking th tv back to where you bought it to see if they will repair it or give you a new one, it all depends on if it is still under warranty. If not it might be worth trying to get hold of a new back light of the internet and fitting it yourself though it can be quite hard and fiddly.post me back if you need further help.

replace c1853 and c1854 in power suply they are boath 1500uf

Sounds like you've shorted something against this led wire. Did you maybe forget to slip that thin piece of paper or plastic back in before installing the new palm rests?
Let me know if this helps