- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Since the Evolution motors, with the aluminum cylinder instead of the cast iron ones, and into the Twin Cam motors, there is a perception of the motor running hot. This is due to the aluminum cylinder being a better conductor of heat, allowing the heat to transfer through the cylinder to the outside better than being more contained by a cast iron cylinder.
Also, the Twin cam runs hotter than any prior Harley motor. In fact, though originally scheduled to be released for the 1997 model year, it took them until a couple of years later to get the heat within an acceptable range. In fact, there was talk about installing an oil cooler from the factory, but that fell by the wayside.
Also, yes, due to EPA emission requirements, they tend to be set to run lean, which doesn't help.
I have a 2008 FLHRC, and at a long stop light, the rear split pipe cooks the inside of my right thigh.
This means that HDD is faulty . You can confirm it by re fixing the hard drive . Shutdown computer > Remove HDD > wait 1 min and Insert it > Start computer . If you get any of the below status Steady Amber (Orange Led) = Drive is Faulty Amber Blinking = Hdd rebuilding
If orange led blinks , it means hdd is in rebuilding state. Wait for sometime and check if it come online . On the other hand (Steady Amber) its time to replace HDD
bh 103 is fail product don't advie to other i suffer lot because i purchsed before 12 houres volue very low it is like 100 rs local ear phone & current it stop working with in 4 minits playback nokia now start bad production & try to foll to all customer
hi
Go to Control panel > Sounds and Audio Devices > Volume. Check that Device Volume is at least halfway across the slider and that Mute is unchecked. Go to Advanced and make sure that nothing is mute. Go to Speaker Volume and set the sliders at least halfway across the slider. Go to Advanced, and in Speakers setup choose Laptop Stereo Speakers (if that's what you have). Go to Performance and choose Restore Defaults. Click Apply > OK
plz do inform if this has sorted out the problem
all the best
regards
Corrupt DB, firmware to reolve on creative website
Try this: disconnect the player from the computer, turn it off,hold in the volume + button, and reconnect the player to the computer while holding the volume + button in. Keep holding the volume + button for an additional 5-50 seconds. Windows should eventually go into recovery mode and revive the player- it will pop up a window that says Found New Hardware Wizard.
×