WHAT CAUSES ERROR E000100

Replace with psu card.
Thanks.

canon ir 3530 shows finisher error (displays spanner)

tengo una fotocopiadora canon ir 3570 y le cambie el cilindro y la cuchilla y ahora no me copia la imagen sale la hoja en blanco

canon ir 6800cn error code e000100-0002 solution

it might just be a power spike in which case your machine just shot an error while it protected itself...

try the following...
press additional functions
press 2 and 8 at the same time
press additional function
press code error
press copier
press function
press clear
press error
press ok
press reset

if that doesn't work then call a tech... it might be very serious...



I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

Ok here is how to reset the error if that doesn't work... you really need to call a tech... you are going to need some serious work done on your copier... ok... here are the instructions

press additional functions
press 2 and 8 at the same time
press additional function
press code error
press copier
press function
press clear
press error
press ok
press reset


I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

code E00024-0001 canon IR 3570

you should be able to go through the print menu on the printer and look for something that says information or configuration and look for network settings and print this page.

ADDITIONAL FUNCTIONS>SYSTEM SETTINGS>NETWORK SETTINGS>TCP/IP SETTINGS

You'll need to replace the fuser unit. Not exactly the cheapest part of the machine...

Unless, that it, you were taking things apart and happened to unplug something accidentally. If you take the cover off where the paper comes out, look at the connectors directly inside there under the black piece of paper that you'll see. If one of those are pulled out, it could cause the problem.

Otherwise you need to replace the fuser unit.

Erice