Question about JVC DR-MV1S DVD Recorder/VCR
Problem:- DVD Player always shows "Disc Error" will not show any DVD. Machine approx 4 years old, little used. Have read troubleshooting guide in handbook but cannot see this problem detailed. Up to a week ago the DVD disc might playback but only after re inserting between 5 and 10 times, but now will not play at all. Any ideas???? Thanks Jack Ewins
I think the player only plays DVD-R discs
Posted on Oct 08, 2007
Try to clean your machine by playing a lens cleaner disc coz the lens might be dirt enough not to pick on data from the discs you play. if it does not work then isuggest you change the lens coz it might be weak
Posted on Aug 03, 2007
Tips for a great answer:
Jan 09, 2012 | Zenith Televison & Video
Jun 29, 2011 | Toshiba SD-K220S DVD/CD Player w/Built-in...
If you have necessary tools and test instruments, know safety precaution in basic troubleshooting try the steps below to solve your problem.
Assuming that the disc is good.
1.Clean the lens. - Sometimes because of dust the lens can't read any disc. Try clean the lens by soft cotton buds. Be careful while doing this.
2.Replace the ribbon - Check the ribbon connected to the lens from the main board for scratch, damage. Once it has an open line then of course the lens can't read the disc. Also try to erase the contact by pencil eraser. If you've done the steps above and the symptoms still there then the next step requires you a little knowledge in soldering technique and reading the ohmmeter.
3.Check the motor - Check the motor that spin the disc with an ohmmeter. You can test it using the ohmmeter (x1) even it is connected on the lens assembly.Good motor - reading should be fairly high and it will spin. Bad motor- reading will drop to low resistance and will not spin.
Hint : 50% of my repaired unit the above parts are commonly caused of the problem.
If you confirmed that you have a defective motor then replace it with a new one. Before replacing the new motor you have to check the clearance of the disc holder with the old one. The clearance should be the same as the old because if not the lens will not read the disc if it is too far or too close.
If the above steps didn't cure the problem, high chance that your optical lens was faulty.
If you can't do the job yourself, I would advice you to look for a
professional to troubleshoot the symptom.
Hope I helped you.
Have a nice day!
Thanks for using Fixya.
Mar 20, 2011 | Philips Televison & Video
Feb 04, 2011 | Televison & Video
Jul 18, 2009 | Coby TF-DVD7005 Portable DVD Player
Dec 03, 2008 | Panasonic Diga DMR-EH75V DVD...
Dec 27, 2007 | Toshiba SD-V392 DVD Player/VCR
Jun 03, 2017 | JVC DR-MV1S DVD Recorder/VCR
346 people viewed this question
Usually answered in minutes!