Cleaning the outside of a rangemaster toledo duel fuel cooker

transformer or power control board going bad

This job is for qualified person. Is not recomadet to doit yourself.

Hello Angela,

does your cooker looks like this one?




Then one of the very small buttons should be for the ignition.
To replace that, you need to remove the control board, as they are screwed at the back.
So work for an engineer.

But I know a much easier way.

Clean your button with brake cleaner, or thinner or something like that.
Try to find the cheapest spray can with silverpaint.
Be shure that you have covered all the parts that you do not want to be sprayed and only spray that part of the button that needs to be silver.

Every one will tell you that you are an Expert.

Good luck with it, Dik

I used to have the same range with 2 electric ovens, but it is available with the lower large oven on gas and the tall oven electric.

The manual for theToledo with tall electric and large gas oven can be found here:

http://www.rangemaster.co.uk/Siteimages/Site_311/BigMedia/Toledo90Gas.pdf

The manual for theToledo with both electric ovens can be found here:

http://www.rangemaster.co.uk/media/575792/toledo%2090%20dual%20fuel.pdf

The main product page for the toledo 90 can be found here:

http://www.rangemaster.co.uk/range-cooking/toledo-90.aspx

how can i replace the manual for this model

junk it and get a new one !!!!

I imagine that the information you need is contained in my article http://www.fixya.com/support/t1416237-timer_instructions_rangemaster_toledo

Hi Sally

I havd exactly the same problem. I contacted Rangemaster/Aga support line (0845 603 5312 if in warranty, 0870 789 5107 if not) and they told me the heating element was shot.

My cooker is 2 1/2 years old, so out of warranty, but they were good enough to send me a new cooker top (top left hand side only of course) free of charge!!!, I just have to get it fitted.

You have to replace the whole left hand side of the cooker top too - the burner that the wok goes on!

Good luck

Yes, the handle, doors and knobs can all be removed, in fact (If I remember correctly) the unit is delivered with at least the handle/rail at the top not fitted. I would still suggest that you visit the supplier with a tape measure and suggest that if they want sell you a unit, they reassure you by showing you a packaged unit, or demonstrate the removal of the handle.

Yes this is easy to do.We can supply bits if required.