Crib slide track is broken

This is tricky but I have put it together and taken it apart countless times (3 kids, 2 houses and everyone switching rooms). All of the screws keeping the crib together need to be as loose as possible without the crib coming apart. I found it easiest to have someone help so they can help hold the crib. It's important not to pull the drop side apart as it will break the plastic slides (I've done this and had to replace them). Have your helper hold one side of the drop crib right against the side piece of the crib and slide the drop side down to detach it from the side your helper isn't on. once this side is detached do the same for the opposite side. On the crib side that attaches to the drop side is a "screw" that slides down the plastic slide and a "peg" at the bottom. I always get the peg out of the track and then you can slide the screw all the way down the slide to get it out.

It's for the brackets. I had to find a site that led me to storkcraft recalls and then it let me choose brackets, then I filled out a short form and I recieved them in a week and a half. Hope this helps.

Jen

check out www.productsamerica.com

It converts from a crib to a daybed, by taking the front sliding rail completely off. The rail will slide up out of the groove.

Hope this helps.

I am not sure if you have solved your problem yet, but all you have to do is slide the front side of the crib off the hinges. The rail that slides up and down, will come all the way off, turning it into a daybed.

I haven't been able to find my instructions either, so I figured that much out. Now I am trying to figure out how to convert it to a regular size bed. :- (

Good luck to you!

Products America can not provide parts for the Sorelle cribs however they should be able to provide you with contact information for the company. You can call 800-205-9642 or 800-772-1041 and speak with a customer service rep who would be more than happy to assist you in contacting the company.

i think this is the same crib that i have. I remove the front rail that slides up and down, then i removed the plastic contraptions that allow it to slid up and down on. I then attached the bed frame on the lowest setting, by first fastening the two back ends first. Then I attached the toddler rails to the bottom of the bed frame and then once they where on I attached the bed frame to the crib with the rails and the brackets for the bed frame pressed together. I hope i explained it so that i makes sense.

You pull up and push in with you knee on the lower part at the same time.

Hi,

I too, need to convert my crib to the toddler daybed. My daughter climbed out last night! Anyway, I was searching for my instructions and then remembered the instructions are attached to the bottom of the mattress board......hope this helps.

Jessica

Hi, replacement parts can be found on amazon, click here: Amazon com Storkcraft Baby crib parts and take a look. Wish you best of luck. Cheers