Kdc-mp208 kenwood kdc-mp208 turns on then off when I turn up the volume

If you press and hold the aud button for a few seconds it should take you to the audio menu. If you scroll through it you should be able to turn loudness off and on.

1:- Select Clock Adjustment mode Press the top or bottom side of the Control knob. Select the "ClK ADJ"/ "ClCK" display. 2:- Enter Clock Adjust mode. Press the centre of the Control knob for at least 1 second. The clock display blinks. 3:- Adjust the hours. Press the top or bottom side of the Control knob. Adjust the minutes Press the right or left side of the Control knob. 4:- Exit Clock adjustment mode, Press the [B.BOOST] button.
Now whats the time, Gotta get my tea.
Regards, Dave

See page 11: http://www.kenwoodusa.com/UserFiles/File/Global/Consumer/Manuals/kdcmp238.pdf

Protect indicates that there is a short or a grounding problem usually within the speakers or the speaker wiring. Locate and press the reset button (pinhole). If protect comes back then disconnect all speakers, reset and connect them back one at a time until protect shows up again. This will help you find out where the unwanted DC signal is coming from. If protect shows up when all speakers are disconnected, then it may need service.

how i do set up the clock mutimidia radio mp4

There is a good chance that your car has a factory amplified system, it may say premium on the speaker covers if it does. Check to see if you hooked up the bue and blue white wires in the adaptor harness. The blue wires in the adaptor harnesses are to turn on the factory amp.

On the remote wire of the stereo always be a blue one

Make sure that the source is set to "Standby" when trying to access the menu. It took me about an hour to figure it out and afterward I felt like a ******.

try 5227

Let me know if it doesn't work

Thanks