I don't know how to program the FRX3 so that it will sit silently until an emergency message triggers it with a tone signal or what ever they use.

Samsung gorgio armani
its in silent mode not able to hear the ring tone

Go to "Profile", select "Silent" and the "Personalize", scroll down and turn off all the tones, eg. Message Alert Tone, Application Tones, etc.. Let me know if you need further help. Good Luck. Thanks for using Fixya.

If your phone is actually in Silent Mode, press and hold down the # key until you see "exit silent mode" or similar notification, doing this will exit the silent mode of your phone. If there's problem with your phone, eg. Speaker or other components, you may need to service it. Let me know if you need further help.
Good Luck.
Thanks for using Fixya.

since you know where the fuses are, you also know where the flashers are. the flashers are the same part so unplug the one for the emergency flasher and put it into the socket for the turn signals and vice versa. if the signals now work but not the emergency flasher you know to get a new flasher unit at any parts store. the flasher units are cubes about an inch on each side plugged into the fuse panel.

Hello

Your phone is probably on silent or you havent selected a tone for your text messages. Go to your tones,select a particular ringtone you want to use for your text mesages select "options" and select ''set as message alert tone" and select ok.

Hi..
This means you have activated the keypad sound, its very simple to deactivate, just go to settings-> tone settings, there you will get the option like "keypad tones" or similar to this.. just select that and make it "off"..
Hope this will help you..

Calls are signalled in two ways. First, check the Ringer switch on the left side of the phone. It's a 3 position switch OFF/LO/HI. If the outside lines are blinking the MESSAGE light, then the ringer is probably turned off. If your intercom calls are toning but not ringing, you may have the AUTO ANS light lit. Press it until it's off and intercom calls will either start ringing or send an audible tone.
If it tones, then you have a programming problem where intercom calls are set to tone instead of ring. That's corrected in system programming.

Carl

Press and hold the # button until it tells you its on normal mode. If this still doesnt work go into settings, profile settings, then i think it will be general and change the ring/message tone as it must be on off..if that makes sense. hope i helped.

If you wish to eliminate or reduce the volume of the end of cycle beep you can do so by powering off the unit and turning back on while holding the right button “Cancel/Reset”. The beep has 3 volumes levels and silent, press the right “Cancel/Reset” button to cycle through the settings. Power the unit back off to save you setting.

In order to set the ring tone to silent you must turn the volume down to silent or vibrate. Go to phone in menu and check on sounds.