Will not print after pulling forward a jammed paper

sounds like a paper jam or a guide problem that feed the paper

print one page and paper jam the next one

1. Slide the paper-width guide to its widest position, and then pull out the paper tray extender. Figure 2: Move the paper guides
2. Insert plain white paper into the input tray with the short edge forward and the print side down. Slide the paper forward until it stops. Figure 3: Insert paper into the product
   CAUTION: Make sure the product is idle and silent when you load paper into the input tray. If the product is servicing the print cartridges or otherwise engaged in a task, the paper stop inside the device might not be in place. You could push the paper too far forward, causing the product to eject blank pages.
3. Slide the paper-width guide inward until it stops at the edge of the paper. Figure 4: Adjust the paper guides
   NOTE: Do not overload the input tray; make sure the stack of paper fits within the input tray and is no higher than the top of the paper-width guide.

it seems that you are correct

Push the button on either side of the rear access panel or the duplex unit and remove the panel or unit.

Check inside the printer to make sure that the cam drawer is in the correct position, toward the front. If the cam drawer is not forward, pull the cam drawer into the correct position.

With all of the paper trays removed, check to ensure that the pick-up roller is up, not protruding down towards the tray, and no media is stuck to the roller.

Remove the printheads and check underneath the carriage and under the printheads themselves. Remove any jammed media.

My C60 Epson Stylus printer is not printing. First of all the paper jammed, I pull the paper from the front and since then the catridge holder is not going to the middle to print. also the green light keepon flashing and the red light stays on. I need your help.

Dell printers are the worst I have worked with, this problem may be a 'paper jam' when there is no paper jam at all (or one REALLY stuck on the fuser). Check on the back of the printer for a piece of paper jammed on a sensor.

You have a broken gear main motor. I had the same problem, bought $5 part and after the replacement of the gear,it runs like new

check the paper path, specially where the paper is being pickup. it might still have a small peice of paper stuck in the path. pull out the paper tray. can check the paper path in the front of the printer.
use a flash light if you can not see inside.
unplug it printer after you finished. wait 10 sec and plug it back in. that will clear the printer of any remaining print job, and rest the printer.

if this solve your problem, please rate the answer.
thank you

your printer need to be opened and check for any lever is struck or dislodge, it will be better if you send it for servicing

turn the printer off, count to ten, then note the light sequence ie: flashing organge solid orange, flashing green or solid green