Edc samsung engine diagnostic control

YOU in UK and have a LORRY (means truck , in ROTW)
EDC 3776 electronics Diesel controller , engine lost power up a hill, sure.
No truck makers name?
no year truck
what size engine/? diesel?
lost power is :
1: bad fuel
2: filters dirty or packed up.
3: injectors clogged.
4: weak pumps.
5: other problems with EDC , scanned and seen,
6: truck needs service. or hill too tall./? IDK I can not see the hill.

You need to have it scanned with diagnostic equipment to find cause, repair fault & reset ecu

You can use some diagnostic tool to check your car. Car Diagnostic Tool

Rail pressure: Leakage in quantity compensation. Check the fuel rail for leakage.

I have an answer for you.The codes are coming from a lost Tachometer memory.Yoour Edc Control Unit and teh Tachometer are not correctly aligned.You need to have th Tachometer reprogrammed.It has lost memory

1.EDC:00959-01 >seconds-Action-Tachometer has lost memory and is not aligning with the Edc Control unit. mixture of time and date>Tachometer to be reprogrammed.

2. EDC:00960-01>minutes- Action-Tachometer has lost memory and is not aligning with the Edc Control unit. mixture of time and date>Tachometer to be reprogrammed.

3. EDC:00961-01>hour- Action-Tachometer has lost memory and is not aligning with the Edc Control unit. mixture of time and date>Tachometer to be reprogrammed.

4. EDC:00962-01>Day- Action-Tachometer has lost memory and is not aligning with the Edc Control unit. mixture of time and date>Tachometer to be reprogrammed.

5. EDC:00963-01>Month- Action-Tachometer has lost memory and is not aligning with the Edc Control unit. mixture of time and date>Tachometer to be reprogrammed.

6. EDC:00964-01>Year- Action-Tachometer has lost memory and is not aligning with the Edc Control unit. mixture of time and date>Tachometer to be reprogrammed.

EDC 03089 -05
EDC = Electronic Diesel Control
03089 = Charge air temprture sensor
05 short circuit to earth

First just turn it off for ten minutes and then restart it,

There is a fault in the LSU unit.
1. Use EDC mode to test the HSYNC signal and LSU Motor.
2. Check the Harness connected to the Engine Controller and LSU.
2. Check the Harness connected to the Engine Controller and LSU. --> Refit the harness or replace it if it is damaged.
1. Use EDC mode to test the HSYNC signal and LSU Motor. 2. Check the Harness connected to the Engine Controller and LSU. --> Refit the harness or replace it if it is damaged.. 3. Replace the LSU

If the problem still happens call a repair tech.

You need to enter the hidden engineer menu: turn the printer off then turn on again whilst holding down the enter key on the control panel. It should say something like EDC menu on the display and you can scroll through several menus to find the one about resetting counters. Be careful not to play with other options as you can screw the printer up if you don't know what you're doing!

im lookin how to fit it as well as i have herd you can not put the m on the wall as the do not have the right thing u need for the telly the braket wichh u can get direct from samsung cost £280.00 wich is mre than wt i paid for the telly wt a rip off