The red light on the cradle starts blinking, I thought it had to stay on whilst charging. I only charged the camera about six weeks ago and have not used it since. It is absolutely dead, even in the cradle there is no response to any controls.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi there, Base on User's Guide of Casio Exilim EX-S600 Digital Camera, Flashing red light when charging the battery is mean "charge error" (see the picture) to overcome some problems that may occur, please refer to the User's Guide of Casio Exilim EX-S600 Digital Camera which can be read here: http://support.casio.com/pdf/001/EXS600_e.pdf
Two reasons.
Either the battery is dead
or
the cradel's charging circuit is faulty. But the red light shows that the cradle is fine.
SO, the axe falls on the battery.
I found this while trying to solve my exact same problem.. It worked for me after about 7 times. Some other people on the site said it worked for them after 20 times. Good luck!
My NP 20 gave me the flashing red light of death and I got Casio to replace it. Then I had the same problem with my second NP 20 so I dug around for a way to fix it and I found the following advice on a site called FixYa. It worked instantly and I didn't risk ruining my battery. ylu1 writes: I had the same problem as this. what i did was... i kept putting the battery on the charger then took it off as soon as the red light came on. i did this about 6 times. doing this puts a bit of charge in the battery each time before the charger starts to flash. after the battery as got enough charge in it it can start to charge. hope this helps.
Here is how you fix the problem (without using a 9V battery method...).
The battery doesn't charge because it's been fully discharged.
What you do is you put the camera into the cradle. Now you see that the Red LED comes on solid for a while. It's charging for a few seconds. Then it starts blinking. When it does that - TAKE THE CAMERA OUT of the cradle.
Now put the camera back and repeat. Do this six or eight times. Each time what's happening is that the battery is getting a tiny bit of charge. After 8 times the LED will come on red and stay solid red.
First off your blinking battery light means you have a faulty battery and you need to have that replaced. Call tech support and they will replace that for you. Once that is charged up all the way then hopefully the camera will work properly for you. If not try resetting it.
Good day on you sir , you have same problem about my friend of mine,, Who have also Exillim S600..
Two Problem you may encounter for that 1st is you need to change battery for that and the 2nd if it not function after you change battery its mean that theres a problem to your current supply need to change repair it into the licence repair man , you may not be worry for the fees coz its only affordable and easy to repair you must avoid those who repair shop that needs you large amount of fees..
The NP20 battery that your camera requires is not taking a charge because of a "charge error". Please contact tech support and give them your address and they will replace the battery free of cost for you.
You can salvage your old battery. Sounds crazy but you can take a 9 volt battery and jumper it to the old battery . It will put enough charge in the np-20 to make it start charging in the cradle. Takes about 20 seconds.. make sure you go + to + .. the size of the 9 volt fits perfectly.
×