I need a disassembly guide for the HP 1040 FAX (or 1010)

HP 1040 Fax User guides

http://h10025.www1.hp.com/ewfrf/wc/manualCategory?product=425911&cc=us&dlc=en&lc=en

replace the main logic board PCB

while the fax machine is powered on unplug the power module from the back of the fax. now press and hold # 3 button at the same time........while holding the two buttons reconnect the power module back into the printer. after plugging back the power module release the two buttons. printer will restart and will start working normally

Look on page 7 , Figure 2-3 for Line connections for your HP 1040 Fax.
http://h10032.www1.hp.com/ctg/Manual/c01420218.pdf

I have one..
There is no fuse..
Try unplugging it for a few hours & see if it clears it..
However it doesnt sound good..
Yea - 220 probably jacked it pretty good..
Probably blew the power suply inside & maybe a few other things..
The cost of parts to fix it will buy a new one..

Hi,

Often, this type of problem is caused by the paper sensor which is nothing but a small switch activated with the presence of the paper(s) pressing on it, It would look like a small tab/lever that would move (to activate the switch) by the paper pushing against it. You would have to inspect this lever/switch and determine if it would move freely. It is very rare for the actual switch to go bad, often it would be just the tab/lever not depressing deep enough to engage said switch.

Hope that this beof initial idea/help. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

It uses an HP 20 inkjet cartridge.

Here is a link to the manual

check the manual

http://www.retrevo.com/search/v2/jsp/downloadPage.jsp?doc=02c3572ff6a11ac342ae55fe4e15c1a2&q=hp+1040+fax

here is the manual

http://www.retrevo.com/search/v2/jsp/downloadPage.jsp?doc=02c3572ff6a11ac342ae55fe4e15c1a2&q=hp+1040+fax&e=1

here is the manual


http://www.retrevo.com/s/hp+1040++fax++manual