Dcr dvd101 multi-selector does not work - DCR Sony Video Cameras

Hi,

You need a pictures motion browser (PMB) installed on your computer.

You can get it at this link :

www.sony-mea.com/support/download/316131

After installed, please use your USB / firewire to paired them.

Regards

sent it back to Sony

The supplied software is not compatible with Mac Computer and Sony does provide any software or driver for Mac Computer for this Camcorder.

However, you can transfer the video to the Mac Computer. Refer the link given below for the instruction:

http://www.kb.sony.com/selfservice/documentLink.do?externalId=C455189


After that you can use any Video Editing Software to edit the video in the Computer.


Good Luck!!!!!!!!!!!!!!!!!!!!

open it up then clean the lens
ben and peter jeffrey

You may have to go to the sony site to download drivers and software for your camera to be recognized

i clicked on Sony CCD Support and the only response I receive is "This article is unavailable". Good support!

I do not see any mirror either in lcd section of your Sony DCR-DVD101 camera as you can see in below picture.
Please let me know your problem with details.

Make sure the selector switch is turned to record (the center position) and camcorder is turned on. Make sure the viewfinder is pulled out fully when you look in it. If that doesn't work try resetting the camcorder. Open the LCD and there is a small hole near the play button, gently push a paper clip in the hole all the way and press the power on button.

hi
i think that your problem is in fuses
u must open it and replace the fuses u will find a diagram inside your camcorder to locate this fuses.
u can remove them and bypass.
bye

Hi there, I got the same problem.

All answers received are to finalize the discs or use Sony discs. Both were tried but nothing. I realize the camera was working Ok with Windows 2000 but that happened when I migrated to XP.

HAve you solved the problem as I see your post is very old.

Regards