The printer has an error stating ERROR 1200 - Lexmark X4270 All-In-One InkJet Printer

My printer (Oki C330dn) experienced a hardware issue that placed it in a mode where it displays a 'Service Call 069: Error' on startup after the hardware problem was corrected. I used the following button combination at startup, which corrected my issue. Press and hold the BACK, DOWN ARROW, and OK buttons and power-on the unit. Continue to hold the buttons until you see RAM CHECK and some asterisks then release. This forces the unit to ignore all warnings and errors while placing it in an online mode. My printer came up to a ready state and worked normally. The next time I turned it on, it started up without any errors.

The 1200 error code indicates that the cartridge carrier has stalled. Please refer to this article 1200 Error Message on a Lexmark X4250/X4270/F4270 All-In-One to fix the issue.

Service Fuser Error appears when the fuser does not warm to the required temperature. For this error on this Lexmark model, the manual states you should power off the printer and power it back on, and if it is not plugged into a wall power point, change it to a power point mounted directly on the wall. Personally, I never got a Lexmark printer to work doing this, but this is in the manual. If this won't help, and the printer is under warranty, you should log it in with the servicing company.
If the printer is out of warranty, your next option is to change the fuser which costs around $300 for a new one, so I think you would be better off getting a new printer unless you find a second hand fuser on Ebay. They usually send for under $100.

The 1200 error code indicates that the cartridge carrier has stalled. Refer to this article 1200 Error Message on a Lexmark X4250/X4270/F4270 All-In-One on how to troubleshoot this problem. If error continues after going through the steps, I would suggest you contact Lexmark technical support so they can further look into this issue. Thanks.

The error 1200 is caused by the cartridge carrier getting stalled. That can be due to several causes. Here's an article in the Lexmark website to guide you to identify and, hopefully, resolve the problem. Just click on this link: http://bit.ly/9QxkWP. Hope this helps. If you need more assistance, place a comment so I can get back to this. Thanks.

Causes of Error 1200 Error 1200 is a critical system problem that is commonly caused by an unstable system registry or corrupt system files that are required to run Windows smoothly. This must be fixed immediately to prevent further problems to your data, applications and hardware

Hardware Error: 1200

The All-In-One is stalled.

1. Press Power to turn off your all-in one.

2. Unplug your all-in-one fro the wall outlet.

3 Check for paper jams.

4 Plug in your all-in-one

Cartridge Error: 1200

The cartridge carrier is jammed.

1. Turn off you all-in-one

2. Unplug the all-in-one form the wall outlet.

3. Open the control panel.

4 Open the cartridge access door

5. Make sure the cartridges are snapped in place in the carrier.

6. Check for objects obstructing the carrier.

7. Plug in your all-on-one

8. Press power to turn your all-in-one back on.

Hope this resolves your issues.

If you need further help, reach me via phone at https://www.6ya.com/expert/david_eb7ea98642566cc6

Hi,

This error is caused by the cartridge carrier stall. To troubleshoot this problem, please visit the below mentioned link:

Troubleshoot - Error 1200


Please rate it Fixya if helpful.

Thank you

Please email to [email protected] for a solution. Mention the error message # 10