Kenwood KHD-C710 MP3 Player Logo

Related Topics:

Question about Kenwood KHD-C710 MP3 Player

1 Answer

Kenwood music keg

Hi, my kenwood KHD-C710 revA has decided to go wild. Now on my stereo monitor it comes up with BUS-E70. What does BUS-E70 mean? pls help

Posted by James Higson on

  • TEKA Mar 08, 2008

    I HAVE THE SAME PROBLEM IN MY KENWOOD KVT-9200DVD

×

Ad

1 Answer

Anonymous

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

And Hi again Teka,

I posted a reply in your other post here.

Regards.

Posted on Mar 08, 2008

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have te Kenwood DDX514. How can I get it to play music videos? thank you

Car Stereo Oxnard Kenwood DDX-418 Demo - Breakers ...

? 2:59
https://www.youtube.com/watch?v=SG6bJ6RHMgQ
May 19, 2011 - Uploaded by Josh Furagganan
But I can't get my iPod to play music on it. ... You need to havethe Kendwood iPod cable to be able to do netflix, music videos, etc. and it's only ...

How to make any video file format play on most in dash dvd ...

? 8:45
https://www.youtube.com/watch?v=8V8hyvguTw8
Dec 9, 2012 - Uploaded by richboy12
How to make any video file format play on most in dash dvd systems (Pioneers, JVC, Kenwood) .... My stereo can't read mp4 so does that mean no music video for me or are there any other ways I can watch music video in my ...

Kenwood DDX770 DVD Receiver Display and Controls ...

? 2:12
https://www.youtube.com/watch?v=IHH5Jhb6O6w
Mar 20, 2013 - Uploaded by Crutchfield
You can watch video on the Kenwood DDX771 receiver's ... Hi, I ordered ddx771 and I can't get my iPhone to play music through the usb.


0helpful
2answers
0helpful
1answer

Hi i would like to know how to connect in ear monitor to my behringer xenyx 1002fx

by in ear monitor I assume you are talking about a set of stereo headphones.
.
These would plug into the PHONES jack, which is located just to the left of the MAIN OUT jacks.
If your headphones have a 1/8 inch jack, you will require a 1/8 inch female to 1/4 inch male stereo adapter.
These are fairly common, and can usually be purchased at any audio store or Radio Shack or The Source by Circuit City.
1helpful
1answer

Hello; I have a used Behringer pmp5000 mixer. The

Without knowing how you have your monitors configured it is hard to analyze what you have posted.

In brief, SW3 on the schematic that selects MAIN L and MAIN R in the upper position, MAIN and MONITOR in the middle, and bridged in the lower is used to configure the internal amps.

In the upper position, the amp power outputs come from the mixed stereo bus and are simultaneously controlled as a stereo signal by the MAIN slider.

In the middle position MAIN and MONITOR, the left amp receives the signal from the mix bus and is controlled by the MAIN slider. The MONITOR output from the other side of the power amp is controlled ONLY by possibly the "MONO" slider.

The schematics are hard to decode and what is needed is a signal flow diagram.

For my uses, I don't try to use splitting the power amps between mains and monitor but prefer to use the mains together with SW3 in the upper position (Note your 27 may be refering to the user manual designation for same switch). I then use another small amp from the 1/4 inch MONITOR jacks whcih are under control of the MONITOR sliders.
Please note that the MIX for these two MONITOR channels is controlled by the MON1 and MON2 knobs for each channel.
0helpful
1answer

Player no longer works

Haha.  Follow the makers' instructions for resetting the thing; the instructions for reloading firmware, if that fails.
0helpful
2answers

ViewSonic E70 VCDTS21569-3P. NO POWER

hi,

Try to check capacitor on the B+ line leakage.
0helpful
1answer

Code does not work

According to Kenwood's car audio FAQ, the stereo needs to be brought to a Kenwood service center to be decoded. You may run into a problem, however, as Kenwood requires a receipt or other proof of purchase in order to prove you are the rightful owner of the radio.

Good luck, I hope this was helpful, even if it maybe wasn't the answer you would like to hear.
3helpful
3answers

CD-ROM Software

I can upload the software if you still need it.
0helpful
1answer

Kenwood in-dash DVD/Sirius/Nav/etc

Hi wonky1,

On an identical problem, I posted a reply here.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.
Not finding what you are looking for?

Open Questions:

See all Kenwood KHD-C710 MP3 Player Questions

445 views

Ask a Question

Usually answered in minutes!

Top Kenwood Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5720 Answers

Morne Olivier
Morne Olivier

Level 2 Expert

264 Answers

 Francisco Mauricio...
Francisco Mauricio...

Level 3 Expert

1551 Answers

Are you a Kenwood Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...