No power My sherwood RVD-6095R receiver does not switch on. I have checked the fuses and all seem to be OK. There is nothing obvious blown or burnt to cause the receiver to not switch on.

Check speaker selection switch. If set properly then perhaps the amplifiers are blown - check for fuses that may be open.

hi,
I have the user manual for sherwood RVD-9090RDS with me. As it is pdf file i can't sent the same through the Fixya. If you can provide your email id then i will sent the same to you email address.
OK

Generally speaking, an amp attempts to protect itself from heat, shorts, overloads and operator exuberance by refusing to turn on or stay on.

Overloads can be from excessive periods of high output or marginally low impedance loading by the speakers; and shorts would be wiring issues or a speaker blowing up.

You should be able to feel if it's hot. WHY is it overheating? Make sure it has sufficient ventilation on all sides and that vent holes are not blocked by dust balls. Ensure the fan (if equipped) is running as designed (some only operate on demand). Clean dust and debris from it.

If the amp comes back on after cooling, you're lucky. They only have so many self-protection cycles in their lives so continuously resetting or cycling their power without addressing the cause can do more harm than good.

If it protects immediately on a cool power up you should disconnect the speaker connections and try it 'nekkid'. If it comes up then diagnose which lead(s) are shorted. If it does not come up the problem is internal and should be left to an experienced and competent hands-on tech.

Here is an official link for you to download the requested user manual. Note that the user manual for RVD6090 and RVD 6095 are the same, according to the Sherwood USA (take a look at this link, at the Discontinued Models you can locate the same manual for both devices)

In case of a problem or clarification or further details needed, don't hesitate to post me a reply before rejecting my answer.
If you are satisfied, rate my solution with the "thumbs" or (even better) add a testimonial.

Thanks and regards
Please kindly rate this solution
Stelios
direct fixya link: http://www.fixya.com/users/technical114

There is a small battery inside somewhere that keeps the presets. It probably needs replaced.

its due to your player there is nothing wrong with fuse... don't crack the case...try this just connect M1 & M2 to the aux input of your home theater

http://www.sherwoodusa.com/pdf/RVD-6090R.pdf


voila

I did solve the problem with the Sherwood receiver R6036-R
The problem was a broken solder Trace towards the power cord on the powersupply board.

Thanks for your concern

Hi cleitner . It has most likely blown a mains power fuse. You will need to FIRST DISCONNECT FROM THE POWER. Then remove the lid and check internal fuses. Best done with an ohms meter to be sure that you don't miss any. Some fuses can look ok but be faulty. Replace any blown fuses with one of exactly the same type. If you are not sure what type of fuse you need, feel free to get back to me here. Good Luck, thanks for using FixYa

regards
Graeme

Do you know the Input and Output voltage on this transformer? The only advice I got 4u is to find the Identical/similar Input/output/wattage for this transformer or find a shop that can rewind a new wire's on that transformer. Hope this may help you