What does F 44 flashing mean before cycle is finished and dryer stops

Buy another machine

Her indoors did this on a regular basis, I just held in the power button until the display flashed and it reset itself. Good luck

My dryer did the same thing, it was so distrubing noise in the middle of drying cycles, so I turned off the sound switch it went away, now it doesn’t peep any more.

Depending on the dryer, it could simply be the wrinkle guard setting. This is the case with my Kenmore (Whirlpool) dryer.

Could be the circuit board at fault

If might have a bad humidity sensor. Call the manufacturer and describe the issue.

Michael Lee
www.thorappliances.com

I remember correctly, F1 means the main board is bad.
Please rate solution

it means that your heater or board are bad

Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x

Filter blocked, disconnect hose from under sink connection and drain into bucket. Hotpoint does not want you to change filter, contact Service Engineer.