No green color in Sony Wega 55inch TV

the color tv display used mixing of three colors, (red, green and blue). it lost one color, coomon problems: lose contact of base of picture tube or its wiring, sockets, capacitor dead in rgb section, dead video ic

bad picture tube , new tv

The color signal consists of Red, Green and Blue. Those three colors, at various degrees, make all the other colors on your screen.

If you have a BRIGHT green screen it's best you don't operate your set.
If it's just tinted green then there is a problem on the CRT (Cathode Ray Tube) drive board. Do check your "tint" setting and see if someone misadjusted it. If that isn't it then you need to have your set on an electronics bench and get an estimate for repair.

dont power your tv near sound box or machines with magnet,

switch off tv, get a magnet and pass it all round your screen, it will clear with no time

Thats great that TV is working fine. How about rating solution as 4 blue diamonds?
Thanks.

Kevin,

for the color problem,most likely you do have problem with loose contact of components from C-board ( small board connected at the back of CRT "picture tube" which drives every color and size of the screen)if you have knowledge with soldering electronic component parts, resolder this board and also check main board for possible loose contact.

cheers,
mark

Please remove any speaker or megnatic thing near to TV.

If you turn the color all the way off the picture should have good black and white if not the crt is at fault. If it is good it could be the jungle ic or the possibly the red color driver in the crt board

It sounds like you have a loss of green. This could be caused by the green gun in the picture tube opening up or the drive circuit for the green gun gone bad. Stargazer

use a 10 ins, speaker magnet to front of picture tube degussing color