I have a Toshiba Tv and I don't have a remote, trying to figure out how to change the input without it so I can play my Playstation 2

Without a remote control, you can't enter its service mode to unlock it. Try to get an original remote control. Contact the authorized service center.

If the remote is its original one, there should be a button marked 'TV/AV'. Press this button to select inputs.

If your TV has a 'Menu' button at its front panel, you can surf through its menus and can set the input select option to make it into tV/Video option. If there is no such button, no other way to select the input selection without its remote control.

Unless there is a source or input button on the set you need the original remote.

Just get a cheap universal remote, and program it to the TV. Some TVs don't have the dedicated buttons to switch inputs, without the remote.

1st check to see if your remote volume down button is stuck. 2nd do you have wireless internet (router) or any other wireless devices phones,ceiling fans, another Toshiba remote, if so try unplugging them (or remove the batteries if it's a remote) while it's changing the volume one at a time. If a different device makes it stop try changing the channel on it. Also make sure the t.v doesn't have a mind of its own and remove the batteries out of the t.v remote, let it ride for a couple days if it happens without the remote being in play then you know your t.v is acting strange, if it stops then starts back up when you start using the remote again then you know your dealing with a remote issue. Sometimes Freq.'s merge causing remotes/wireless devices to conflict with each other.

Try this website 1-800-remotes Factory original u can buy an original remote,tries Channels up or down couple times u should get in the input 1 or 2.

yes as long as it has the button for it.look for tv/video button.if none, then buy a remote like a universal remote is the only option.

usually if you change the channel doen pass channel 2 then it will come across the different inputs. otherwise is there an input button on your remote? if so then push that button until you get the input you want.

On either the front of the TV or a universal remote (which I assume you have already programmed) hit the MENU button. Go to option 4 "Channel". Go down to "List and Labels." Hit the CH up or down key until you see "FRNT" come up under the channel # heading. If your DVD is connected and playing, you'll see it playing now. Exit the menu to watch. You'll have to reverse the process to get back to watching TV, but there doesn't seem to be any way around this if you don't have your RCA remote. This process is guaranteed to work on an F27442 and will probably work on some other RCA models.