Machine does not complete the wsh cycle and we cannot open the do

Ok that might be for your filter it might be full. You can check that from inside the shell or should be one the tub.

the door is not locking , possibly caused by the interlock itself or motor brushes worn ( most likely if machine is a few years old at least ) could also be no power to lock via control board .

This is completely normal, the machine puts water into this chamber during the rinse cycle to wash the softener into the machine.

Your machine is still under guarantee. Contact the dealer who sold you the machine and make it his problem. Trying to do anything to the machine will void your guarantee.

Try cleaning out the dirty water pipe. Mine was completely blocked up with scale and soap powder. We used a coat hanger and went from the out side as well. The water now pumps out completely without leaving any left under the drum

Error code F03 indicates wash thermistor open/short circuit.
Check all connections on thermistor and associated leads.
Hope thisn helps.

put a full load in it, its telling you that, try 20 shirts, or 10 towels

hi, it may have a dry solder joint you could find.
a new display can be bought from hotpoint for about £55 according to their website.
http://www.hotpointservice.co.uk/hs/pages/index.do
if your machine is less than a year old it's a guarantee job, if under 5 they fit the part free but charge for call out. a local engineer may give a better quote. it's a 5 minute job to replace.

Hi
my washing machine is 2 years old, hotpoint wt761p showinf f-01. it hasnt finished it cycle. turned off by mains to open the door and get washing out.

please help!!

stella

Press "end of cycle button" for over 5 seconds, it will unlock. Note: the door should be opened only on hearing a click, or wait for 2 minutes after the wash completes.

I need a rating please, dont forget(!)