Question about Mitsubishi WS-65869 65" Rear Projection Television

Mitsubishi WS65905 Projection TV

The picture is cuvred and the colors (red, blue and green) are separated. The TV was left on accidentaly for about 20 hours with just a blue screen showing. Is there an easy adjustment that will fix this or should I call a repairman. Thanks

3 more comments
doleinc Jan 26, 2009

I have the same problem. Is this worth fixing? What can I expect to pay for the repair?
tvstuff Mar 09, 2009

the blue and red are not lined up the blue and red are not lined up
Anonymous Mar 29, 2009

convergence is all screwy.... I used to be able to "Fonzie" it but that doesn't work anymore.
Anonymous Mar 23, 2014

screen appears more green and gray lost red in color scheme
Anonymous Mar 28, 2014

the red blue and green aren't adjusting properly color is off but I have a picture

2 Answers

Anonymous

Level 1:

An expert who has achieved level 1.

Problem Solver:

An expert who has answered 5 questions.
Contributor
3 Answers

Convergance ics and sometimes resistors go bad. call a repairman...

Posted on Aug 01, 2007

Anonymous

Check convergence amps

Posted on Jul 13, 2007

1 Suggested Answer

6ya staff

2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

Posted on Jan 02, 2017

Add Your Answer

Upload

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

1 Answer

Mits. rear projection tv ws65905 picture has blue color tint

Your blue picture tube is failing. Invest in a new TV. "If" you can find a new set of tubes(you have to replace all 3 red blue and green) they are around $800-1000. Not cost effective. Run the TV into the ground if you want to wait but do not invest any repair money in my opinion.

Jun 01, 2015 | Mitsubishi WS-65905 65" Rear Projection...

1 Answer

I would like to know ow yo fine tune my Yellow and Green colors on my Mitsubishi HD 1080 Series

If this is an auto convergence you may be in for a bit more of a project than you want to be into. If there are separate color guns then you can adjust them individually with a screwdriver from inside

Nov 09, 2013 | Mitsubishi Televison & Video

1 Answer

I have a 46" rear projection Mitsubishi TV that recently started producing a wavy picture. The reds, blues, and greens separate into wavy color bands distorting the picture. It usually goes away for...

your problem is most probably in convergence circuit. very common for this model to have convergence output i.c.'s go bad also possible that a fused resistor or two has failed.

Jul 28, 2010 | Mitsubishi WT-46809 46" Rear Projection...

1 Answer

My tv is showing blue when i turn it on i think my blue projector light is out?

i have a mitsubishi vs-60111 when i watch the tv as of last week the color is pale like green color or green,gray color the picture is sharp yet , i took front cover off the lights are still bright red , green and blue what can be the problem / joe

Nov 06, 2009 | Mitsubishi VS-60111 60" Rear Projection...

2 Answers

My tv color is blue and red is my lamp out or what

no your optic block is going south u need a new light engine big bucks

Sep 20, 2009 | Mitsubishi WS-55859 55" Rear Projection...

1 Answer

Mitsubishi tv model wd 73727 and how to take tv apart to clean marrow

my mitsubishi 73" set is 4+ years old. all of a sudden the color is all wrong. after a couple of minutes of clear picture the colors change--blue is green and red is yellow. a little while later everything has a red tint to it and there is a line going down the center of the screen. to the left the picture is still relatively sharp, but the right hand side is terrible. I'm hoping this is just the lamp.

Rick
Woodland Hills, Cal.

Apr 12, 2009 | Televison & Video

1 Answer

Picture turns to red & green and becomes blurred.

This is likely solder connections cracking on your convergence ICs. If you can bump the tv and it goes back to normal, it just needs resoldering, but if it doesn't, then it needs the ICs replaced. If the convergence is out, you will see a bowed picture and the red, green, and blue will be separated. Worth repairing if you can find a company to do it affordably, I can help you repair yourself if you have disassembly and soldering skills.

Dec 03, 2008 | Mitsubishi WS-65809 65" Rear Projection...

1 Answer

Red Blue and Green?

All colors in a tv are made up of red ,blue and green,,. my projection in the menu has under setup,,just check for it,,its called conversion ,it realines the colors,, you have to do it periodicaly,or sooner if you move a projection tv,, thanks,, .it should have it,,good luck

Oct 05, 2008 | Mitsubishi WT-46809 46" Rear Projection...

1 Answer

Mitsubishi VS-50605 - Colors separated

You have a convergence problem and need to reset

Nov 26, 2007 | Mitsubishi VS-50605 50" Rear Projection...

1 Answer

Problem with color

Yes you have a problem in the red crt driver board. Most likely the driver transistor is failing. This is a component level repair, so if you have no experience with TV repair, play it safe and call in a trained tech to assist you in this matter. Good Luck

Jun 05, 2007 | Mitsubishi VS-50609 50" Rear Projection...