The full trigger alert icon is illuminated on my avital 5303

hello
u will find a lot of wiring diagrams, codes etc and circuit diagrams help books and stuff like this at online places.. like reliable-store
for free

the girl in the chat box can help u instantly... im a frequent buyer there since Im a mechanic so take help from there

yes it is

It should go to this site http://www.the12volt.com/installbay/forum_posts.asp?TID=52897 it shows your Pirus if you go under the tab vehicle wireing, manufacture, model.

be sure the polarity of a battery when you fix it in the remote unit

Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try free

you check to see if the engine was hot or something like if the water level in the radiator was down the sensors in the security system would pick it up

Remote start the vehicle using the remote.

Forget the yellow wire. Its for wiring WITHOUT an alarm. Connect the red to a fused 12 volt and the black to the orange "ground when armed" of the Avital 5303.

Oh yes. You will need an interface for the remote starter to work. You can purchase an FLCAN or an XK09 but, these components must be programmed to function properly. You can purchase an EVO-ALL; it does not need to be programmed. The installation instructions can be downloaded at ifar.ca. The three components mentioned above will work almost necessary components in the vehicle . Hardwire the system with 5303 and then wire the interface to the vehicle through the CAN data wires.

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to us.. U get free manuals