Question about Whirlpool 2 Person Corner Air Tub By Vitabath Bathtubs

1 Answer

Whirlpool corner tub not working

I have a corner whirlpool tub and it will not come on. I checked the fuse box and it is ok. It has an powerbutton on the tub and a wall switch. There are no access panels to get into the tub area and I don't know where the pump would be to check it out and I don't want to tear up my walls to get in unless I have too. The tub was all ready here when I bought the house. Any ideas?

Posted by dailydecatur on


1 Answer


  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

You wiil need to check 2 things.First you will need to check the motor.Their should be a reset switch on the motor.also attached to the power buuton is ablack thin hose if this hose came off the switch or motor than the motor wont come on.Look around for an access door .If thier is acloset in an adjoining room you might find it thier.

Posted on Feb 02, 2009


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Jacuzzi tub will only turn off if tub is empty

This sounds like maybe you have a bad circuit on the control that turns the pump on/off.
Get the model number off the control box under the tub and let me know what it is and we can solve that issue for you.

US Parts Center

May 03, 2014 | Jacuzzi EH0 / EH1 / EG9 Fuzion 6666 Corner...

1 Answer

I have a U.S Whirlpool Jacuzzi tub that has been installed for about 6 years but have only used 5 or 6 times. We have not used it in over a year and now we cannot get the motor to run. We checked the...

Call a local bathtub service company but check to see it the tubing on the back of the motor has come off. If your tub turns on/off with an air button on the top of the tub, that tubing has to be hooked up in order for the pump to be able to turn on/off.

let me know if you need further help. I would need to know what the control looks like on the top of the tub in order to further assist you.


Jul 29, 2011 | Jacuzzi - Whirlpool - Corner - Gallery...

1 Answer

Off on switch on response

need to test motor may be overheating or burnt up pump

Apr 02, 2010 | Whirlpool 2 Person Corner Air Tub By...

1 Answer

I have a 2000 Sovereign Hot Spring hot tub that quite heating, I checked filters they are ok, I have no air lock, The jets and light work fine. Inside the control box on the circuit board all 3 led lights...

Check for a bad heater controller board or burnt wire connection going to the heater. You can check for voltage across the white and black leads going to the heater from the heater controller board (upper left corner of the black control box

Mar 31, 2010 | Waterway 5 Hp 230 Volt 2 Speed Side...

1 Answer

I have a corner jet tub, I need to know where the rubber hose goes on the motor from the switch.Please

The rubber hose usually goes on the back of the black box located on top of the motor. There is usually a nut that comes off, the hose goes through this nut, the hose then fits on the small nipple in the center of where the nut was removed. Slide the nut up to the box and tighten finger tight to hold the hose in place. If there is no box on the pump. follow the electrical plug from the outlet, sometimes the control box is mounted on the tubing or side of the tub.

Sep 28, 2009 | Jacuzzi EH0 / EH1 / EG9 Fuzion 6666 Corner...

1 Answer

Whirlpool dishwaster quiet partner I - 5 years old

it could be bad thermal fuse or loose wires in jbox at bottom .to chkd therm fuse remove the screws the on top of the door holding the control panel.then pull out the panel and u should see cntrol board on the rhs of the panel.the thermal fuse is mounted on rhs corner of the control board.remove wires from fuse and chk for continuity.if open replace.if ok remove toe panel at the bottom and remove the screw of j box at rhs bottom corner.chk for loose or burnt not forgot to unplug the unit from power before doing all this.good luck

Aug 18, 2009 | Dishwashers

1 Answer

Jets wont work

is there a way for you to get acces under your tub. a door? if so check were the pump is and follow the power supply? there should be a switch or check your fuse pannel in your house?

Dec 16, 2008 | Jacuzzi EH0 / EH1 / EG9 Fuzion 6666 Corner...

3 Answers

My jacuzzi stopped turning on.

I would check all power to the tub. Is it plugged straight to a breaker, plugged into a GFCI, GFCI breaker in the master panel? For it to just stop altogether I would think something tripped.

Oct 21, 2008 | Jacuzzi EH0 / EH1 / EG9 Fuzion 6666 Corner...

Not finding what you are looking for?
Whirlpool 2 Person Corner Air Tub By Vitabath  Bathtubs Logo

Related Topics:

834 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Home Experts

john h

Level 3 Expert

23424 Answers


Level 3 Expert

4369 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

33449 Answers

Are you a Whirlpool Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides