Question about Philips 42PF7320A 42 in. Plasma HDTV

1 Answer

42" plasma Can't get the red its all green I tried all the hues etc/ what should I do

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 92 Answers

If your using component cables check to make sure they are seated well
if so try swapping the blue and red if red is still bad you probobly have an issue with the SSB

Posted on Mar 12, 2008

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the perfect amount of red,blue,and yellow hue for the screen


that's got t o do with personnel preference and room lighting , but as a general rule adjust color hue's till the edges of a white color object on screen has just lost its primary color edge

the older projection TV's actually have voltage numbers for the service tech to adjust them too , but im not remembering seeing any in the LCD manuals

Mar 29, 2016 | Element Electronics FLX3210 32 in. LCD TV

1 Answer

My screen has little dots appearing sometimes red sometimes blues behind the picture i just replaced the lamp bulb as i thought it would cure the problem


the projection tube needs to be adjust for color alignment, each tube (red, green, blue) must be aligned so you there would be no color smear appear on screen. if it is aligned try to set up the color balance, hue etc.

Feb 06, 2011 | Samsung Televison & Video

1 Answer

There is too much green color, i tried hue - contrase - lite etc. but the color is still green


how do i get the red and green hue back on my olevia 227-s11 tv my screen is blue and brown

Dec 09, 2009 | Syntax OLEVIA LT20HV 20 in. LCD Television

2 Answers

Our Sony Grand Wega suddenly has a green-yellow tint.


IF IT IS HOOKED UP WITH COMPONENT CABLES (GREEN, RED, AND BLUE) FOR PICTURE AND RED AND WHITE FOR AUDIO, MOST LIKELY THE RED ONE IS NOT SEATED PROPERLY, CHECK BOTH ENDS THE ONE CONNECTED TO THE TV AND THE ONE CONNECTED TO WHATEVER THE SOURCE IS ( SATELLITE BOX, CABLE BOX ETC.

Oct 06, 2009 | Sony Grand WEGA KDF-42WE655 42" Rear...

1 Answer

Some times the picture gets a green and red hue and the menu turns from green to red ,


HI. this is being caused by a faulty convergence chip that is located on the convergence board. simply replacing this chip or replacing the entire board will fix this issue.


May 21, 2009 | Sony BRAVIA KDL-40S2010 40 in. LCD...

1 Answer

Looks like 3D tv


Try doing a calibration. Projection TVs work with 3 picture tubes (Red, Green, Blue). The Red may be off to one side causing the hues.

The manual is available here for instructions on how to perform calibration:
http://www.retrevo.com/samples/Hitachi-manuals.html#Projection%20TV

Apr 06, 2009 | Hitachi Televison & Video

1 Answer

Sony KP-53V45 color issues


When ever a tube starts to short or is shorted set always will have over bearing drive lines then shut down like RED if it was bad, set would come on long enough for red lines across set then shut down this is the same with all 3 tubes.Also if you think it might be green tube disconnected green CRT board on neck of green tube if set comes on and plays then it is green tube do all 3 tube this way one at a time this will tell you if you have other problems.

Dec 02, 2008 | Sony KP-57WS500 57" Rear Projection...

1 Answer

Green hue on all inputs


Most likely there is a failure in the video processing. The flickering was from the failing components breaking down.

Your set can be serviced by an experienced tech who has spare boards and the facilities to service your set.

Jerry G.

May 13, 2008 | LG 42PX5D 42 in. Plasma HDTV

1 Answer

GREEN AND RED HUE IN PICTURE WITH CABLE OR DVD


Convergence amp ic bad
http://home.earthlink.net/~oleg.filippov/ConvergenceFix.htm
http://cmpalmer.blogspot.com/2006/11/fixing-my-own-tv-part-ii.html
http://www.hdtvoice.com/voice/showthread.php?t=28929
Or send to ptscorp.com
http://www.hdtvoice.com/voice/index.php?s=



Feb 12, 2008 | Televison & Video

Not finding what you are looking for?
Philips 42PF7320A 42 in. Plasma HDTV Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76204 Answers

ThaMp3Doctor
ThaMp3Doctor

Level 3 Expert

8597 Answers

matt martin
matt martin

Level 3 Expert

1257 Answers

Are you a Philips Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...