Kenmore 20.3 cu. ft. / 575 liter Upright Freezer 23024 Logo
Alice Fern Posted on Jan 10, 2013

Freezer control pad stuck in off position

Pushed the quick freezes button then it locked me out, I tried unplugging it to reset but nothing,

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 2 Answers
  • Posted on Jan 11, 2013
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Jan 11, 2013
Answers
2
Questions
0
Helped
374
Points
2

Hold the lock button for three seconds, hope that works

3 Related Answers

Anonymous

  • 311 Answers
  • Posted on Nov 28, 2008

SOURCE: Kenmore Upright Freezer

Control is bad and needs to be replaced. I cannot see your repyl due to some tech issue w/ the site, so it may be a day or so before I can reply again. Please leave feedback for me if appropriate. Thanks

Ad
buddymcl777

Bruce McLeod

  • 67 Answers
  • Posted on May 01, 2009

SOURCE: Freezer compressor runs steady & getting -30F

You probably have a defective thermostat or sensor for reading the temperature.

Anonymous

  • 103 Answers
  • Posted on Jun 12, 2009

SOURCE: Freezer alarm stuck on - can't reset

Hi: Does the freezer have a battery backup for the electronics? A 9v. battery in the grill down below. You won't have to remove the grill but pull a small rectangular panel to expose the battery. High end Kenmore freezers have a battery to back up the alarm. The six you see is actually supposed to be a "b" for battery most likely. L.E.D.'s are tough to tell the difference. Buy an new battery and all will be well. I hope this helps, Jeff

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Power freeze light does not come on

Hi rigbyrr - The Power Freezer light indicates that the freezer is properly connected to electrical power. Is there power to the unit? The light glows even when the temperature control is turned to OFF. Let's try reprogramming the freezer by either unplugging it or flipping the household circuit breaker to the off position. It is important to wait approximately ten minutes and then turn the unit back. If the issue persists, check to ensure that the appliance temperature control is in the ON position and that the plug is not loose and tightly pushed into electrical outlet. If everything is properly set then in this regard, I would suggest contacting an Authorized Service Technician that will be able to assist you in the diagnosis of your unit.
0helpful
1answer

I can't turn my Kenmore upright freezer on.

Try disconnecting power for about 30 seconds, and then restore power. This will reboot the control and maybe restart.
0helpful
1answer

How tro restart my digital freezer?

Can you hear the compressor start? If not try the extreme freeze button. Check the condenser is clean and fan working ok.
0helpful
1answer

How to stop alarm of freezer

Unplug it for about 10 minutes to allow any capacitors to dissipate. Switch back on. If alarm starts straight away, suspect faulty controller, probably caused by the spike in the power supply
Apr 18, 2012 • Freezers
0helpful
2answers

Kenmore elite upright freezer service manual mod# 253.28093800

There is a lock on the display. Try pressing standby button for 10 secs
1helpful
3answers

KF48 Beverage Air Freezer permently stuck on "defrost."

Unplug the fridge overnight and defrost it completely. Ensure the thermostat is properly set.

If it does not restart normal function after you plug back, then there may be a fault concerning the digital control, in that case call the number listed on the owner manual.
0helpful
1answer

Kenmore Upright Freezer

Control is bad and needs to be replaced. I cannot see your repyl due to some tech issue w/ the site, so it may be a day or so before I can reply again. Please leave feedback for me if appropriate. Thanks
0helpful
2answers

Freezer not freezing

Hello jannette859,
huuum at your service

You said,
freezer was working fine had to unplug it due to evacuation, now it doesn't freeze, is there any reset buttons? i didn't turn the temp selector to the off position before unplugging

Try turning off the temp. switch off.
Then plug it in and turn the temp on!
this may reset it.
Repeat one more time and let me know ho it went!


How old is the appliance?
If the appliance is 10 years old or more you may not be advisable to put good money into bad!
New appliances are so much more efficient today that they can save you a lot of money in energy!!!!
You need a hands on tech for this repair!


Bless You huuum
Please give me the best rating at fixya .com before you sign off.
Thank You


Not finding what you are looking for?

177 views

Ask a Question

Usually answered in minutes!

Top Kenmore Freezers Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Kenmore Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...