Question about Water Heaters

1 Answer

Reset button flashing on halted boiler, had red light before

Red light came on overnight on boiler didn't come on, pressed reset button, boiler now on but light is flashing blue and not permanent blue

Posted by jo dewsbury on

Ad

1 Answer

Born Again Virgin

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 19 Answers

Make and model?

Posted on Feb 26, 2013

Ad

5 Related Answers

andyshaw578

  • 1 Answer

SOURCE: fault light flashing 1 flash per second

Prior to writing the above fault I had asked the owner to turn the boiler temp controller , for the heating side, down just a fraction . I was phoned this morning to tell me that the boiler had stayed on allnight with no fault light . After consulting with the plumber who fitted the system it appears that there might not be a room stat ,

Posted on Dec 01, 2008

Ad

Anonymous

  • 700 Answers

SOURCE: Boiler problems

heres a copy of the serviceing manuel for the unit. just click on the link and download the manual. http://www.ariston.co.uk/uploads/doc482c2cada6e71.pdf good luck

Posted on Jan 11, 2009

Earnest Bowes

  • 234 Answers

SOURCE: vokera mynute 14se lockout reset button on

Has the boiler cool down? Try turn the power off for a few minutes and see if that will work.

Posted on Mar 15, 2009

Rod Davies

  • 150 Answers

SOURCE: flashing red light on Worcester 24i junior combi boiler

Pressure is ok? at 1 bar or above
I think on this one there should be a reset button [red] on the left hand top of the casing - or lower the control panel [ phillips screw on each side] and the button is on the left of the base plate. Press this and try the heating.or hot tap
P.S. if you're on a prepayment meter check you have gas.

Posted on Nov 08, 2009

Testimonial: "Thank you, very helpful advice. Still got the plumber coming to check everything over but the boiler is up and running for now. Thank you so much"

Anonymous

  • 1 Answer

SOURCE: My boiler is not working, not heat, no hot water,

your condensation pipe may be frozen get a hairdryer on it or a hot kettle that should sort it thats the whit pipe on the left usualy plastic

Posted on Jan 09, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a greenstar boiler its 16 mths went out today blue light flashing checked the condensation pipe was frozen have cleared it out the flue looks ok but im 72 years old its snowing and its bitter


The condensate pipe must be piped into an interior drainage pipe or it will freeze. Turn off the red emergency burner switch to reset the boiler. Also make sure that your flue pipe is clear of snow and doesn't have residual condensate freezing up and blocking it. If it is not pitched back to the blr, it can freeze and clog the flue. This will cause your press switch to cut out on high pressure.

Mar 01, 2018 | Water Heaters

1 Answer

How to fix my Worcester green star ri boiler?


The gurgling sound sounds like you have gotten air into the system. Try purging the air out at the bleeder valves. Also check and make sure that your water inlet is working.

May 29, 2016 | Water Water Heaters

1 Answer

Intermittent lockout


One of or both of two problems. The ignition board could be on its way out and needs to be replaced and or the flame sensor/igniter may be dirty and need to be cleaned or the porciline may be cracked and it's grounding out when it try's to light. I would replace both anyway and problemed solved. Good luck

Sep 08, 2012 | Water Heaters

1 Answer

I've got a Alpha 240 e combi boiler..... Everything seems to be wor,kin ok but it won't start the ignition sequence .


could be air presure switch which tells pcb that fan is working and would then bring inn ignition system then main gas valve.Would suggest getting gas engineer in.pommie engineer

May 26, 2012 | Water Heaters

2 Answers

I HAVE A HALSTEAD ACER HIGH BOILER AND IT IT IS SAYING LOCK OUT ON THE BOILER WHAT CAN I DO TO FIX IT


The overload button is on the left underside of the unit. There is a finger sized hol and the button is in there. Once you have reseet the button you will also have to reset the boiler by using the switch on the control panel (furhtest left switch).

Dec 03, 2009 | Water Heaters

1 Answer

Flashing red light on Worcester 24i junior combi boiler


Pressure is ok? at 1 bar or above
I think on this one there should be a reset button [red] on the left hand top of the casing - or lower the control panel [ phillips screw on each side] and the button is on the left of the base plate. Press this and try the heating.or hot tap
P.S. if you're on a prepayment meter check you have gas.

Nov 08, 2009 | Water Heaters

1 Answer

My boiler will not reset and the green light keeps flashing


The nozzle on the burner is probably clogged. Have a service tech who is qualified look at the burner. Pressing the reset button repeatedly will fill up the chamber with oil and create a dangerous situation.

Apr 01, 2009 | Water Heaters

Not finding what you are looking for?
Water Heaters Logo

Related Topics:

345 people viewed this question

Ask a Question

Usually answered in minutes!

Top Water Heaters Experts

Brad Brown

Level 3 Expert

18439 Answers

Paul Carew

Level 3 Expert

3518 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Water Heater Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...