I purchased my V1003 in the Fall of 2007. Was pleased with its performance. A few weeks ago, I inadvertently dropped it overboard. I retreived it before it sunk but it was virtually submerged. It is inoperative with the lens out. Can it be repaired and if so, who and what would it cost.

The cost to repair is about the same as the cost to replace and you must send it back to Kodak for repairs. About 6 weeks turnaround.

Are you connecting to your own wireless router? If yes, have you changed anything in its configuration, or inadvertently reset it? If you're connecting to someone else's router (neighbor, etc.) it could be that they have locked you out. Does the wireless network show as secured? This sounds more like a security issue than hardware or driver.

this light can come on even thought service is not actually due. if the service was performed and the light was not on at the time, sometimes you cannot reset them if they are not actually lit, or 99% of the time the technician forgets if the light was not on. stop by your shop and they can reset it for you in just a few moments, and for no charge. good luck!

Replace the water inlet valve . Water is seeping thru the valve when closed . Drops of water seeping thru and freezing inside the fill tube . After replaceing valve , be sure to remove the ice from the fill tube .

A new screen is availably from virtualvillage dot com for about $45. I replaced one last week. It only takes 20 minutes and a small screwdriver. The ribbon cable is held in by a flip up lock at the main board.

Hi Cacy,
I don't want to offend you, please don't take it that way, but since your problems began with the addition of the new battery... I have to ask the question. Are you absolutely sure you bought the right battery for your camera?
It takes a NB-2LH battery pack. If your sure you purchased the correct battery for the camera, and since you dropped it, I would check to make sure it seats properly in the camara and that it locks properly. Also the cover should close with a CLICK sound. If it doesn't then perhaps the battery is not locking in properly. Double check it and let me know if you still have problems.


Rob

go into the bios and select the system too boot for cd, put in cd 1 and it should ask for the others

Hello!!!

please remove your batteries and press the power button for few seconds and replace the batteries now and try switching on ...





Regards
Smilemaker.

Recommend sending it off to Canon anyways, but include a short note in the package stating your first three sentences above. Canon should fix the CCD image problem for you for free, including free shipping both ways. This is regardless of your camera's warranty status. Please check the following two links for more info:
http://camerarepair.blogspot.com/2007/11/canon-digital-cameras-showing-black.html
http://www.usa.canon.com/consumer/controller?act=PgComSmModDisplayAct&fcategoryid=225&modelid=13390&keycode=2112&id=29819
Applicable cameras include:
A40, A60, A70, A75, A80, A85, A95, A300, A310, S1 IS, S60, S200, S230, S330, S400, S410, S500, SD100, SD110, IXUS V2/300/400/430/500, IXY Digital 200a/300a/400/450/500