Question about Kenwood 1060VR Receiver
Check all the push buttons and switches on the front of the unit are set where they should be set. In particular the speaker and tape monitor buttons. If there is a "pre out" "main in" set of jacks in the back of the unit, then be sure it is jumpered with stubs or if that unit uses a switch to perform the jumpering function be sure it is enabled. I hope this helps you.
Posted on Jun 28, 2007
Tips for a great answer:
Carefully examine the front panel for clues like a misplaced Mute or Tape Monitor control or Multichannel Analog Input selected.
There is a good chance that a common control may have developed a high-resistance or 'dead
Usually answered in minutes!
Step 2: Please assign your manual to a product: