Question about Motorola Mobility V220
When you make a call just place the call on hold then dial the other number
Posted on Jul 03, 2008
Check to see if your Panasonic phone has a flash key feature. If it does, press the flash key down and wait until you hear the confirmation tone. If the Panasonic phone you're using does not have a flash key, hold down the the hook switch for half a second, then release. Dial the number of the third person in your conference call. If you're inviting someone in-house to be a part of your conference call, dial their extension number instead. If you're dialing an outside line you may need to dial 9 before dialing the number.
Wait for the new addition to the conference call to answer and then press the Flash key again. Wait an additional two or three seconds before pressing the number three on your telephone keypad. Start your conference call. Once you've pressed the flash key followed by the number 3, as in Step 4, your conference call is established. If you wish to add additional participants simply repeat Steps 3 and 4.
Regards
I believe that if you reach a busy signal, you can hang up. The conference should ring you back and the rest of the conference will be there.
Here's what the documentation shows from within the help of a 3300 ICP/MCD...
a 5303 is to be treated just like a 2500 series set...
2500, 5302 IP
Phone, SUPERSET 401, SUPERSET 401+, and SUPERSET 4001
telephones:
To form a Conference when a two-party call is already in place, or
to add another party to an existing Conference:
Press Flash or flash the
switchhook.
Dial the number of the next party.
Wait for an answer.
Press Flash or Flash the
switchhook.
Dial the Conference Call Feature Access Code.
To Leave a Conference:
Hang up.
2500 telephone:
To split a Conference and speak privately with the original
party:
Flash the switchhook.
Dial the Conference Call Split Feature Access
code.
39 views
Usually answered in minutes!
×