Kenmore Elite 45986 Front Load Washer Logo
joseph brugnoni Posted on Jun 19, 2007

Kenmore two speed automatic washer top[ load

The wash cycle works, then it stops Manually I set it for rinse ,it will then rinse .Then I set it for spin and it will not . The drain is not plugged . no kinks .No clothing obstruction. The cold and hot hoses are also clear . I drained it and took a look underneath. Saw the pump (direct drive to the motor. Did not remove pump (three screws. did not see a lint filter. Help

1 Answer

A

Anonymous

Can only be blocked or a blocked air trap. Regards Engineer

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

My Kenmore series 80 washing machine will not automatically do the drain, rinse & spin cycle.

Hi,

please rotate your cycle dial in the opposite direction of its usual motion by 90 degrees (probably counter clockwise). Then you can run the cycle again and the drain/spin/rinse should work. Otherwise, please power cycle your washing machine.

Thank you.
0helpful
1answer

Kennmore 110.22422. 100 hummms when reaching the spin cycle

your timmer button has given up replace the timmer and it will be fine
1helpful
1answer

My kenmore top loading washer 70 series wont go into spin cycle

check the lid switch some washers will fill and was with the lid open but will not spin, if the lid is closed manually actuate the lid switch or bypass it electrically, or replace it.
3helpful
1answer

Kenmore front-load washer stops at rinse cycle

When the washer initially fills for the wash, is it only hot water entering the drum? Try switching the water temperature between hot and cold as it fills. If any of them show little or no water getting through, it sounds too easy but check to make sure water supply taps are on, and that the cold/hot fill hoses aren't reversed. Remove the fill hoses and check any of the screen filters for blockage (in the hoses and in the inlet water valve). When the machine stops and waits to fill but all you hear is a hum, it sounds like there is power going to the valve but water is not able to get through it.
Good luck!

0helpful
1answer

Washer won't stop filling and go to next cycle automatically

if not running over ck to be sure drain is proper height and end of washer drain hose is not too tight in standpipe sound like siphoning after 1st wash and not filling to advance to rinse also be sure washer dring hose is not more than 6-8 in into standpipe
0helpful
2answers

How to work my washer?

the timer change by itself. You don't have to change anything.
But cold rinse only works if you have the cold water connect to the washer
Not finding what you are looking for?

142 views

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Alexander

Level 2 Expert

171 Answers

vince

Level 3 Expert

2530 Answers

Cindy Wells

Level 3 Expert

6677 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...