Question about Kwikset Powerbolt/Electronic Deadbolt- Polished Brass

1 Answer

I have a kwikset deadbolt model 898 keyless entry and it beeps 3 times after programing

Posted by bpressman on

Ad

1 Answer

anastasia bizieff

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Combination was rest key in locked room do not know combination

Posted on Mar 02, 2013

Ad

1 Related Answer

Jan Berardi

  • 1 Answer

SOURCE: i have a kwikset deadbolt

I had the same question as my son installed the lock. Instructions should be printed on the cover you remove (inside the house). They need to make removing that cover MUCH easier, I'm always afraid I'll break it. Anyway, you press the button once for the first number. To enter a "guest" code, press the button twice then enter the 2nd code in the keypad and press the lock button. Now try both main # and guest #, both should open ttthe lock.

Posted on Sep 30, 2011

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need a video how to program my keyless entry deadbolt lock


Which manufacturer made the keyless deadbolt lock? Make sure that the batteries are good in the unit.

I have an older Weiser Powerbolt deadbolt lock that is programmed by taking off the cover on the inside of the door. This model has handheld remotes and the keypad. Inside there are three yellow buttons. Two match the cover's lock and unlock buttons. Press and hold the third button (in the center of the set of buttons). Then enter program in the code within a few seconds and press the enter button to set the code. If the unit beeps again, the code is set. If the unit doesn't beep, retry from the press and hold the Program button step.

Another model of the Weiser Powerbolt lock has the Program button either on the top left or lower right hand side of the board (depending on the way the door opens) under the cover. Press the Program button once and then enter the 4-8 digit code. Press the Lock button to set the code. If you hear a long beep, the code was accepted; otherwise try to program your code again.

Kwikset Powerbolt locks are programmed the same way as the second Weiser Powerbolt described above.

Kwikset SmartCode locks have their Program button in the center of the bottom of the control board. Otherwise the programming is the same as that given above for the second version of Weiser Powerbolt locks.

MiLocks have three buttons in a horizontal line. The left-most button is the Set button. Press this then enter the code followed by the Unlock button. The code must be entered within 5 seconds of pressing set.

Baldwin Hardware's Boulder series of keyless entry deadbolts are programmed just like the Kwikset SmartCode units.

I don't know of any videos. Most manufacturers do have PDF files with the programming instructions.

I hope this helps. Please add more information about your deadbolt for extra assistance.

Cindy Wells
(I end up replacing the batteries often on the lock I have; it seems like they last 6 months or less.)

Oct 20, 2013 | Deadbolt ELECTRONIC DEADBOLT KEYLESS ENTRY...

1 Answer

Just installed keyless entry lock. Lock button works fine, enter code and deadbolt only partially retracts. Worked fine the first time, will not completely unlock since. Key works to fully unlock. Tried...


Your lock is under one year warranty, with a lifetime warranty if the problem is mechanical or the finish.
Here is a link to the website warranty information, and from there you can contact them for technical and warranty assistance:

http://www.kwikset.com/Customer-Support/Warranty-Information.aspx

Good luck-and please provide feedback if this helps!

Oct 11, 2011 | Kwikset 907 907-15 Satin Nickel Powerbolt...

1 Answer

How do I errase the code and reset a new code on my kwikset powerbolt keyless entry door look


Follow this link to find out how to remove the cover for your Powerbolt:

http://www.kwikset.com/Customer-Support/Product-FAQs/Faq/50160000000HhhEAAS.aspx

This link:

http://s7d5.scene7.com/is/content/BDHHI/40486-02

is the "manual" for the installation of the lock. Programming instructions are found on Page 6.

I'd recommend changing the 4 alkaline AA batteries at the same time.

Good luck!

Jul 05, 2011 | Kwikset Powerbolt/Electronic Deadbolt-...

1 Answer

When i hit the lock button all buttons light up flash and beep and it does not lock


You did not list the model of your Kwikset lock, but I will send you a link to the installation instructions for the Kwikset electronic deadbolt:

http://s7d5.scene7.com/is/content/BDHHI/40486-02

Mar 27, 2011 | Kwikset Locks & Locksmithing

1 Answer

Was unable to get the '2 beeps' when attempting to set up keyless entry instructions. What do I do now?? Keys ok but no keyless entry possible,,,


Here's a link to the installation and programming for your lock:

http://s7d5.scene7.com/is/content/BDHHI/40486-02

SEE PAGE 9 (Troubleshooting tips) for your answer about the two beeps.

Here is a link to Customer Support:

http://www.kwikset.com/Customer-Support/Contact-Us.aspx

Good luck!

Mar 05, 2011 | Kwikset Locks & Locksmithing

2 Answers

I have a kwikset deadbolt model 898 keyless entry.i need to change pin number on keypad outside


I had the same question as my son installed the lock. Instructions should be printed on the cover you remove (inside the house). They need to make removing that cover MUCH easier, I'm always afraid I'll break it. Anyway, you press the button once for the first number. To enter a "guest" code, press the button twice then enter the 2nd code in the keypad and press the lock button. Now try both main # and guest #, both should open ttthe lock.

Feb 04, 2011 | Kwikset Powerbolt/Electronic Deadbolt-...

1 Answer

Why doesn't the back lights work on my Kwikset 907 Power 1000 Keyless Entry Deadbolt? Are there any other batteries beside the four 1.5 alkaline batteries?


Installation instructions for the Kwikset 907 link:

http://s7d5.scene7.com/is/content/BDHHI/40486-02

A note about PDF files: If you cannot view a given file, you need to first install Adobe Reader. You can get the free download here:
http://get.adobe.com/reader/

This is the link to Weiser Customer Support Page, where you will find the appropriate number for your location:

http://www.weiserlock.com/en/CustomerService/ProductSupport/SupportContact.aspx

Oct 21, 2010 | Kwikset 907 907-15 Satin Nickel Powerbolt...

1 Answer

I installed the Kwikset 907 model last night and it was working fine. Tested it several times, showed the family, etc...Everything worked great. My son left for 10 minutes and came home and it no longer...


Why is my Powerbolt beeping?
http://www.kwikset.com/Customer-Support/Product-FAQs/Faq/50160000000HhhEAAS.aspx

Follow this link to find out how to remove the cover for your Powerbolt:

http://www.kwikset.com/Customer-Support/Product-FAQs/Faq/50160000000HhhEAAS.aspx

This link:

http://s7d5.scene7.com/is/content/BDHHI/40486-02

is the "manual" for the installation of the lock. Programming instructions are found on Page 6.

I'd recommend changing the 4 alkaline AA batteries at the same time.

Good luck--and please provide feedback if this helps!

Oct 11, 2010 | Kwikset 907 907-15 Satin Nickel Smart...

1 Answer

I have had my Kwikset Powerbolt 1000 for about a year now and I think it just died! The deadbolt won't move. It will only move one out of every 25 times or so. I just replaced the batteries again. It makes...


Why is my Powerbolt beeping?
http://www.kwikset.com/Customer-Support/Product-FAQs/Faq/50160000000HhhEAAS.aspx

Follow this link to find out how to remove the cover for your Powerbolt:

http://www.kwikset.com/Customer-Support/Product-FAQs/Faq/50160000000HhhEAAS.aspx

This link:

http://s7d5.scene7.com/is/content/BDHHI/40486-02

is the "manual" for the installation of the lock. Programming instructions are found on Page 6.

I'd recommend changing the 4 alkaline AA batteries at the same time.

Good luck--and please provide feedback if this helps!

Sep 20, 2010 | Kwikset Powerbolt/Electronic Deadbolt-...

Not finding what you are looking for?
Kwikset Powerbolt/Electronic Deadbolt- Polished Brass Logo

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kwikset Locks & Locksmithing Experts

Charles Tidwell

Level 3 Expert

475 Answers

ray gallant

Level 3 Expert

70046 Answers

STEVE SPAM REMOVER

Level 3 Expert

36769 Answers

Are you a Kwikset Lock and Locksmithing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...