Question about Philips 55PP9363 55" Rear Projection HDTV-Ready Television
I have a philips projection TV model 55pp9363h/17. Unit power up have sound but no picture. Three tube isn't lighting up. I change the flyback,horizontal output transitor but have the same problem. Fly back isn't oscillating. 15khz going to the horinzontal driver. Do you know what else could cause the unit from not oscillating. Thank you.
My TV Akai PT46LP10 was playing then the picture disapere but not the sound. Green light is flashing when I put the power on and never stop flashing.
The sound is ok but no picture black screen only.
Thanks for your help
Posted on Jul 01, 2009
Sometimes projection sets have 2 fuses one for audio and one for video if the one for video is blown replace it if it blows again after you turn it back on there is whole new problem if it wasnt the the flyback to begin with
Posted on Dec 06, 2007
Lets see, This might be a shutdown circuit problem (protector resistor and capacitor are a part of this circuit). You may want to check if the Horizontal oscillator is working if not I would use something like the VA62A to do some signal subsitution. By providing horiz drive to the HOT you can see if the problem is in the HOT, the IHVT or if the problem is at the oscillator. This is a start. Since you replaced the IHVT and the HOT it looks like a possible oscillator problem. However you will not be to tell until you get a drive signal going into the HOT.
Posted on Sep 03, 2007
Check the damper diode and the protection resistor in the High Voltage circuit. Good Luck.
Posted on Jun 19, 2007
Tips for a great answer:
Usually answered in minutes!