Cannot get the Pro-96 out of PAUSED mode

I would visit the Radio Shack site--most aside from the button reset have another way to do this that will clear the issue.

Might also try to Google the model number with keywords to see what you can find.

time for a new one

you may have to reinitialize your scanner

Just about any electronics/radio shop can repair your scanner, but for the best job with factory trained technicians, factory parts, and a repair warranty, you can take the unit to any Radio Shack and they will either have the job done locally or send it in for factory repair.


Bill B

take unit apart replace power jack there the power jack is shorting out insided the jack

Are you hearing any communications at all? Sounds to me like someone has programmed the ctcss tones for each frequency. Try programming a frequency without a tone and you should get a squelch. If not then you probably have to return to the repair shop. GOOD LUCK.

You more than likely want the FM mode. If you are listening to a trunked agency then you will have to know if they are on the MOT, or EDACS system and choose the correct one.

fm mode

Well I would check up on their current frequency. They may have changed frequencies overnight. It does happen. Here is a handy website to check out. Look around and hope it helps you.
http://www.radioreference.com/apps/db/

Check the Plug in where the Harness Comes into Look for Broken Conns,,,,