Red light inside freezer blinking. chilled water dispenses. Ice maker does not seem to be getting any water. Stop making ice 2 days ago.
Before going to buy any parts
directly. This is list of refrigerator problems,
which is normally faced in refrigerator. -------------- ------------ ------------- http://alltypesofpartsreplacing.blogspot.com/2011/10/ice-maker-stopped-making-ice.html ------------- http://alltypesofpartsreplacing.blogspot.com/2011/10/water-overflows-in-ice-maker-and.html ------------- http://alltypesofpartsreplacing.blogspot.com/2011/10/how-to-replace-ice-maker-assembly.html These will help. Thanks,.
Go through this troubleshooting help links.
-------------------------
You can go through the details, by clicking the link below:---
Refrigerator is not cooling properly?
http://technoanswers.blogspot.com/2011/06/refrigerator-is-not-cooling-properly.html
-----------
Both refrigerator and freezer not cooling properly
in refrigerator?
http://technoanswers.blogspot.com/2011/06/both-refrigerator-and-freezer-not.html
----------
The ice maker not working: ---
http://technoanswers.blogspot.com/2011/06/ice-maker-stopped-working.html
Compressor not running on refrigerator?
http://technoanswers.blogspot.com/2011/10/compressor-not-running-on-refrigerator.html
--------
Water dispenser not working on
refrigerator?
http://technoanswers.blogspot.com/2011/10/water-dispenser-not-working-on_19.html
Ice maker stopped making
ice?
Water Overflows in Ice maker
and freezes inside?
How to replace Ice maker
assembly?
Where exactly is the water inlet valve, and how is it tested? I get water from the door, just not going into the ice maker...
SOURCE: ice maker stop making ice red light flashing
http://www.dryerpartsonline.com/4389102-Icemaker-Optics-Control-Board_p_626.html
SOURCE: My icemaker has a red
Hi Please check the water inlet valve, it might be frozen or blocked
with mineral deposit. Use a hair dryer to remove the blockage. Make sure the
water inlet valve's screen is not blocked. If the issue persists, then the
water inlet valve has gone bad, use a multimeter to test the water inlet
valve's continuity. Hope this
helps...please post back for further assistance. Daniel
1,902 views
Usually answered in minutes!
×