Will a 090 carb fit a 051av

No, the Honda Fit model VMX-090 does not have a built-in DVD player.

I can't say for certain this ceramic replacement crock will fit exactly, so check with the dealer to make certain. (It appears to be the right size). https://www.crock-pot.com/parts-and-accessories/slow-cookers/replacement-stoneware---crock-pot-7-quart-cook-and-carry-oval-slow-cooker---black/163875-000-090.html

first of log out account or open in new private windows. facing any issues call 0-800-090-3966 toll free for help Facebook technical support number 0 800 090 3966 FB Customer Service

metric, 090-154 14mm-1.50

Sounds like the carb needle valve is stuck closed. Try loosening the bolts holding the carb to the engine, then tapping the carb lightly with a hammer. If gas then flows to the carb, re-tighten the carb bolts evenly and not too tightly.

Check cooling fins on cylinder head are clean, clean filter, clean exhaust, all these things help disperse heat from the engine. Make sure fuel/oil mixture is correct.

I have the PARTS DIAGRAM if you need it. send your email and i will pass it on.

You have an internal circuit leak in the body itself, my friend. Get a new carb, it's still going on a $1000 saw and will make it run like new again.

Good Day Bob!

This one costs $117.99 and you can purchase it online from the link below:

http://www.powerpayless.com/ac-adapter-replace-yhi-090-02180-13-power-supply-for-protron-sova-a.html

It is an AC adapter replace YHi 090-02180-13 power supply for Protron, Sova, A


Please rate my answer.
Thank you for asking Fixya

I can repair the bad YHI 090-02180-I3 adapter for $60 plus shipping. Let me know if you still have it. [email protected]

Line from tank with the filter on it is the supply line and goes to the carb inlet fitting. This is typically on the "bottom" of the carb (with the tank being up) and will usually have a fitting with barbs or a bulge on it to ensure a tight fit. The other fitting on the carb is the return line and is usually a straight tube fitting with no barbs. That line goes the suction side of the primer bulb. The third line goes from the outlet of the primer bulb to the return barb fitting in the bottom of the tank. Fittings have to be removed from tank to properly install the new hoses on them. Remove retainer ring on outide of tank and push fittings into tank, then shake out of the fill opening. More details on replacing hoses are listed in another post about Repairing Ryobi trimmer.

Have you checked the spark plug?