PART # OF FLYBACK KV-27V65

The flyback transformer for KV G21Q2S is a high-efficiency, cost-effective solution for power supply applications. This component has an excellent temperature range and can operate between -40°C to +105°C. Moreover, https://metalroofingrichmondva.com/

https://www.youtube.com/watch?feature=player_embedded&v=w7kifWMf04c

Hi. In almost all flyback trafo's there is a potmeter(knob) where you can adjust the focussing voltage. In some cases however, there is a separate HV potmeter with a connection to the flyback trafo. Normally there are two wires coming out it it. One for the acceleration anaode (25-29 kV) and another mostly thinner wire going to either the CRT socket (4-5 kV), or this divider unit with focussing potmeter. Servicecodes won't help here. These are only for geometry, ctr bias etc.

Hello
Are the lines across the entire screen, at about an inch apart to each other? Are they thin whit lines acorss the screen; so many of them?

Hello
These lines are calle vertical retrace lines. Try to eleimitate them by adjusting its screen control. Screen control is inside the Tv, can be located at the LOT.

Hello
You must press function before you can control PIP with the yellow labelled buttons.
Press to change the TV channel in the window picture.
Press to move the location of the window picture [counterclokwise] around the main picture.
Press to freeze the window picture with Freeze button.
Press freeze button on the remote handset again to restore the previous screen.
Ok

Dear all
I use a Sony crt tv Model KV-LX34M80 in long time but some days ago I face a problem in my television, Emgg, say's damage my television flyback. So I code not find flyback in my location. Please help me.

Hi,
It can be repaired if you are handy with electronics stuff repair and can replace parts in circuit board with proper tools.
Please ask chat expert the details about 10 times and 4 times blinking error code and do the repair as per instruction.
Thanks.

4 times blinks shows problem in Vertical Deflection area. Please check Vertical Output IC and its supplied volts.

1}Take batts out of remote,in case it is sending from a stuck button. 2)Check all tactil switches 3)Check for liquid spill damage in area of micro and tact switches.