Logitech Access keyboard

Try removing the battery for 15 mins then replace the battery.

Push the button on the base (not the mouse, but the part that plugs into the computer) to re-establish wireless communication

Make sure you have fresh batteries in the mouse and keyboard:

Plug your transmitter unit into an USB port,push the connect button on the TX, then push in on the connect button on the mouse and the keyboard. Also, install the cd that came with the KB/Mouse, to gain access to the features.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response. Happy Holy days!

Thanks, Joe

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

You either need to push fn button (upper left on keyboard) or you need to check that the logitech keyboard software (itouch and a few other names i can;t recal) is running or installed. On mine if the software has glitched out, a quick reload of it and it works fine. This software is what is telling your computer what the special keys mean. If this isn;t running it will only be able to understand the standard type of key signals.

Could be interference from a wireless device using the same frequency. Locate any other wireless keyboard/mice from the vacinity and try it again. Also, push the connect button on the bottom of the keyboard and see if that helps. Also make sure the base station of the keyboard is close enough to the keyboard/mouse.

Hit the reset button on the keyboard or on the transmitter so you can pair the keyboard with your pc.

remove batatarrys and make again if u cant do..

push on the little button at the bottom of the mouse and slide the top bottom half of the cover toward you. The mouse require 1-AA.
negative of the battery towards the left click button.

You need to reboot the PC and it will be fine.
Otherwise, if your mouse is working then go to the device manager and uninstall the keyboard and then restart the PC with Keyboard Driver Installation CD/Setup.
Let me know if you face and difficulty and need further assistance, I will assist you further to fix the problem.
Best of Luck & Have a Nice Day Puneet

Normal 0 Press the Receiver button (and the lights will start flashing.
Then if the Keyboard isn't working, press the small RESET/CONNECT button on the back of the board to connect the keyboard to the receiver.

If the MOUSE isn’t working, push the small RESET/CONNECT button on the back of the mouse to connect to the receiver. Then they should work okay.
Hope this helps. Bud