Location format garmin 72

Try your phone directory or better yet 'google it' that way you can give your location as there could be several near you. A lot of supermarkets have a western union (at least true here in states)

I just looked up:
grafton new south wales electronics repair
On Google.

It came up with:
Downes Electronics
King Ln, Grafton NSW 2460, Australia
(odd that there's no telephone number)

Repairs & Spares
140 Fitzroy St, Grafton NSW 2460, Australia
+61 2 6642 1911
(shows as next door to Downes, they might be the same place)

East Coast Electronics Grafton
Electronics Repair Shop
43-47 Pacific Hwy, South Grafton NSW 2460, Australia
+61 2 6643 3103

Big River Appliance Repairs
Appliance Repair Service
53 Armidale St, South Grafton NSW 2460, Australia
+61 2 6643 2722
(appliance repair place might repair electronics, might not)

Nowra Fair Shopping Complex, 60/32-60 East St, Nowra NSW 2540, Australia Phone:+61 2 4422 0044
see google maps

Each zone of the United States has a specific zone number that the compass has to be set with..
It depends where you live...Check dealer or owners manual for zone setting...You should have a reset button at dash area....If you ever change battery you will have to reset compass zone normally.....Zone numbers are all single digit I believe.....I am on east coast...S.East...Which is 8 or 9...pending state...................Hope this helps............Metalpoet..........

Garmin updates new Maps annually, if new roads were built after the last update you would need to buy the new Map to get the roads...

Make sure the co-ordinates are in the same format on both GPS units. There is a difference between degrees and minutes vs decimal degrees.

If this fixes your problem, please come back and rate our solution. Thank you.

Go to Garmin.com and search for your specific unit, to the right will be a download link for manuals.

Normally a grocer or department store or hardware store will sell replacement bulbs of this type.

You can take the old one with you.

Otherwise, try:

Daewoo Electronics Australia PTY. Limited. (DEA)
Unit Q5, Regents Park Estate Princes Road East, Regents Park NSW 2143, Australia
Tel: 61-2-9738-5111
Fax: 61-2-9738-5511

We're happy to help you and we'd appreciate your thoughtful rating of our answer.

I eventually solved the problem by firstly doing a restoration of default settings. This allowed me to toggle but it was between two different presentation styles of latitude and longitude. To restore the grid co-ordinates option I went to main menu, the Setup, then then toggled to location and re-selected UTM UPS as the location format.

Any bluechart that has been preloaded on an SD card should work.  Did you purchase your chip with the data preloaded or did you download it yourself?  If you downloaded it yourself, try erasing the sd card, format it, then insert the blank card in the 420 and power it up. This somehow preps the chip for the data download.  Then download the bluechart onto the chip and try again.  There is some ambiguous wording in the download screen that makes it look like some kind of error, try the download anyway and most of the time it will work. After the download is complete it should list the bluechart software version on the screen along with some other software info.  If the operating system software is not v2.5 or higher, you may need to download a software update first.