FORD AUDIO SYSTEM jbl fovf-18C807-AB wiring diagram

There are basic wiring details for jbl f5lf-18c807
BL = Blue
N = Natural
BK = Black
O = Orange
BR = Brown
PK = Pink
DB = Dark Blue
P = Purple
DG = Dark Green
R = Red
GR = Green
T = Tan
GY = Gray
W = White
LB = Light Blue
Y = Yellow
LG = Light Green


For more details i suggest click the link below and follow the diagrams that will help.

https://carrepairworld.blogspot.com/2021/06/jbl-wiring-details-for-car.html

thanks

See page 2 of this manual:
http://www.prospecelectronics.com/manuals/JBL%20MR5%20manual.pdf

Are you able to tell me the year and modle the amp came out of. Cannot seem to find this part number with Ford so this would help........

You cannot wire through the jbl amps you need to go to the amp and can only wire in the speakers

http://documents.victorytechnologies.com//documents/product/2322.pdf

www.metra.com u need the harness bypass kit for factory amp , or run wires from each speaker to amp you want to use

RANGER FUSE PANEL Fuse Position Rating Circuit Protected 1 7.5 Amp Power Mirror 2 — Not Used 3 15 Amp Parking Lamps 4 10 Amp Left Headlamp 5 10 Amp On Board Diagnostic (OBD) II System 6 7.5 Amp Air Bag System/Blower Relay 7 7.5 Amp Illumination Switches 8 10 Amp Right Headlamp/Fog Lamp System 9 10 Amp ABS System 10 7.5 Amp Speed Control/GEM System/Brake Interlock 11 7.5 Amp Warning Lamps 12 10 Amp Front Washer System 13 15 Amp PCM System/Stoplamps/
4WD/ABS/Speed Control 14 10/20 Amp ABS System 15 7.5 Amp Air Bag System/Alternator 16 30 Amp Front Wiper 17 15 Amp Cigar Lighter 18 15 Amp A/C System 19 25 Amp Ignition Coil/PCM System 20 7.5 Amp Radio/GEM System/Anti-Theft 21 15 Amp Hazard Lamps 22 10 Amp Turn Signals 23 — Not Used 24 10 Amp Starter Relay/Anti-Theft 25 7.5 Amp Speedometer/GEM System 26 10 Amp 4R44E/4R55E Trans./Backup Lamps/DRL System 27 10 Amp Underhood LP/Map Lights/Glove Box Lamp/Dome Lamp/Visor Lamps/4x4 Sys. 28 7.5 Amp GEM System 29 10 Amp Audio System 30 — Not Used 31 — Not Used 32 — Not Used 33 15 Amp High Beam Lamps 34 — Not Used

Go to 12Volt.com.
They have every vehicle make and model. Plus other wiring conundrums.

ok on most amps there are two sets of wire ports one for speakers & one for +12v,grd & 12v remote start if you look over each port it will say what port is for what wire if it is in a connector it gets slightly more complecated what you do is with a vm check from wire to chassis ground [like seat bolts] 12v with key off when you cet power isolate wire then turn key on till radio comes on then do the same test for 12v isolate that will be remote start then turn key off &check from the first wire to other wire for ground to find speaker wires connect a regular peace of wire to chassis grd & touch the wires you will here the speaker pop be sure not to hold the wire on long cause it will blow the speaker

hey check out htis web-site
www.mobileinformationlabs.com
check out wiring diagrams, those might help you. good luck