Question about Smeg FAB32 Bottom Freezer Refrigerator

2 Answers

Smeg Fab 32 door problem

I have a smeg FAB32 fridge freezer and have noticed that the fridge door is out of line and does not seal properly. The gap between the top of the door frame and fridge is 2.7cm at the top and 2.2cm at the bottom. Is it possible to adjust the hinges? I am fairly practical.

Posted by Gavin Dancy on

Ad

2 Answers

Anonymous

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The Door on my SMEG Retro Fridge keeps opening on its own accord ? There's nothing inside poushing up against it so why does this keep happening ?

Posted on Dec 13, 2009

Ad

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 183 Answers

Remove the lower hinge on the fridge door and pack out using a piece of cardboard resrcew the hinge onto the door, this will resolve the problem Regards Advisor Smeg Agent

Posted on Aug 21, 2007

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

What s the switches inside fridge

prob green power yellow or orange fast freeze
0helpful
1answer

SMEG fridge freezer, freezer door was left open and it defrosted. we have turned the applience on again freezer is contantly triping and it is not working. red light is on constantly. please help

the relay is timing out this was caused by over run try turning off for 1 hr to let it settle and decompress if it does the same fit a new relay and try if that does not work it meens the compressor has gone expensive repair
3helpful
1answer
2helpful
4answers

Smeg Fridge light

What you need to locate is the door switch mechanism for the fridge. These are normally located towards the top of the door and protrude so that when the door closes the switch is pushed in. To find out if you have a problem with the switch just press it when the door is open and the light should go off. The switch itself can appear in various forms either as a protruding rod or a curved plate which pushes upwards against the door side when it closes. If I could draw in this section it could be better explained. But if you look around the inside of the fridge on the side away from the door hinge then you should find something you can push. Sorry to be this vague. If you do need a replacement switch they are normally quite simple to change depending on where they are located, most are two screws, or just a push in type. Hope this has been of some help.
Jul 04, 2008 • Smeg FAB28
0helpful
1answer

I have a 2 year old SMEG FAB 32 Fridge/Freezer and the freezer section has suddenly lost temperature. Upper frdige section is fine but freezer not. I have emptied, kept door shut, turned dial up but no...

I have a 2 year old SMEG FAB 32 Fridge/Freezer and the freezer section has suddenly lost temperature. Upper fridge section is fine but freezer not. I have emptied, kept door shut, turned dial up but no success.

Any suggestions on what the problem might be?

Wouldn't expect problems on a SMEG just 2 years old.


You could have a bad thermostat or the refrigerator could be low on Freon, make sure you clean off the exposed coils on the back of the fridge and underneath to free it from dust and dirt – use some type of a blower for underneath and the coils you can vacuum off or wipe off the coils, if not call a service tech to have a look @ the refrigerator – it might have a bad compressor
0helpful
1answer

Widths

no
what part of the world do you live as there is other manufactures
0helpful
1answer

Leaking Fridge

you may have a faulty defrost timer, best consult a local dom apps store.
0helpful
2answers

Freezer problems

remove back panel of freezer. check if there is excessive ice build-up preventing air flow. if there is, then defrost carefully with a hairdryer (with appliance switched off) if no ice or frosting on pipework, check if compressor is running. if it is or hot to the touch or clicking, then you have a compressor fault and replacement is not diy. if compressor not running, then probably module fault
Not finding what you are looking for?
Smeg FAB32 Bottom Freezer Refrigerator Logo

2,144 views

Ask a Question

Usually answered in minutes!

Top Smeg Refrigerators Experts

Mike

Level 3 Expert

4377 Answers

Jay Finke
Jay Finke

Level 3 Expert

1391 Answers

 Mikey
Mikey

Level 3 Expert

6726 Answers

Are you a Smeg Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...