An expert who has achieved level 2 by getting 100 points
MVP:
An expert that gotĀ 5 achievements.
Governor:
An expert whose answer gotĀ voted for 20 times.
Scholar:
An expert who has written 20 answers of more than 400 characters.
Expert
125 Answers
Re: Need to set time
These clocks uses the same family of IC's.
There should be a button labeled 'time' or 'time set'.
Push and hold this button, then press a button labeled 'H' or Hour, you should see the hour advance. In some models, if you press the button long enough, the advance rate will become faster. Press the button labeled 'M' or minutes and the same procedure applies.
After that release the 'Time' button
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There are two ways to find the user manual for your Timex watch.
Find your watch on the list below and click on the language link for your manual.
Find the 3-digit module number located on the caseback of most Timex products and click on the corresponding language link for that number in the Module Table.
If you are still unable to locate your user manual, you may emailTimex Customer Service or call us toll-free at 1-800-448-4639.
www.atsco.info/.../CTX%20DKT-IP%20Handset%20User%20Guide.pdf Hi please find above your user manual. Also often, well, sometimes, on the side/rear of the phone, there is a small slide switch, that is used to control the ringer, or as related hopefully the manual will show you how.
I have attached a link to the user manual for this camcorder. The time and date settings are located in the menu options under "SYSTEM". Page 43 of the user manual will walk you through setting it up.
The lens must be set to F/22 on that model so the camer can set the aperture. Setting it to 22 tells the camera it is ready, so the camera can actually set the proper f/stop according to the light level. You can set the aperture yourself using the control knobs on the camera - in manual settings. In Aperture, or Shutter settings, you can set the aperture or shutter speed and the camera will set the right exposure. On Program, the camera sets both aperture and shutter.
×