Sportsart 1080hr has power, but only red emergency stop lights are flashing. Magnetic key in place. Nothing happens if I reset the emrg stop?

HELLO USUALLY THERE IS A PATTERN TO THOSE BLINKS FOR EXAMPLE 2 BLINKS PAUS THEN 2 BLINK

4BLINKS PAUS THEN 4 BLINKS

LOOK CLOSER AND TELL US THE PATTERN

You need to connect the battery. Lock and unlock the car with the remote. That will cause the ani-theft to stop flashing the lights. It does, however, stop after 3 minutes. That is, until you disturb the vehicle again. Then it starts the 3 minutes again. You need to get the remote out, and lock the doors and unlock the doors. Done.

It could be that you did unfold the treadmill completely.

Yes, it is likely that it is the switch directly underneath the magnet - it may be possible to bypass it, but not a good idea. You can order a switch direct from Woodway 1800WOODWAY

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/russell_1d1c35fa8a5a0be4

try again to answer this one as live chat keeps interfering ,anyway this fault is the factory immobilisor and as its encrypted software the only ones to sort this out are the dealers ,but a few tips ,when it happens try spare key ,keep the key away from a mobile phone ,old style television screen ,security scanners adsn outside electrical EMF field can wipe the memory from teh chip in the key as its only a magnetic bar code when all is said and done

We have the EXACT same problem! Would love to hear a solution to this. It will eventually work again but we have no idea what brings it back to life. I've tried the reset button, unplugging and replugging numerous times and still get the KM and 579 showing up and then no power.

i just called the manufacturer on this and found out i have a faulty control panel, but these are the steps they told me to go through to reset. If it works, then you are good, if not, you may also have a control panel issue.
1. plug in and turn on treadmill, keep red key out
2. press and hold the stop button and speed up button at the same time and hold them while you insert the red key
3. after red key is inserted, let go of both buttons
**CAUTION - be sure to stand on side bars of treadmill, clear of the belt for this next part bc it will go VERY FAST***
4. press stop button once
5. press speed up button until it reads 85 (see what i mean?!)
6. press stop button once
7. press incline down or up one time and it should get back into normal mode. mine just started a series of flashing lights and "8"s in all the "windows" so my panel needs to be replaced. here is the number i called - 1-877-993-7999. Good Luck!

Just put mine up & it did the same thing. Unplug power. Have remote handy & paperclip. Find reset hole behind remote. Plug in power, red light will flash, hold reset button in until unit stops flashing. Make sure remote is also powered on. Thats it.

I have the same problem. It seems we have to reset the counter. This reset must be done via the beamer itself and not via remote control, since lamp is not working...

The magnetic switch was stuck due to power outage / contactor are spark connect the contactor stuck together .Magnetic switch to replace.